Code
Goodlark GT100 Bluetooth Headset
Thank you for choosing and using Lark's TWS Intelligent Wireless Earphone E-100. We will assist you to
operate this Bluetooth earphone. Before using the product, you need to know how to operate your
cellphone or other Bluetooth device function.
The left and right earphone of this product can be used separately (mono) or for pairing (stereo)，
Stylish in appearance, and high quality stereo, Enrich & enhance your lifestyle and enjoy the quality of music
Anytime, Anywhere~
Product function and parameters
Product model: GT100
Type: Half-in-ear touch Bluetooth earphone
The left and right earphone can be used separately (mono) and can be used in a pair (stereo)
G sensor touch to wake up
Contact charging, including charging box
Goodlark APP, massive audio content, high-quality listening.
Wireless Bluetooth earphone
Product model: GT100
Executive Standard: Q/DKBA 2425-2017
Bluetooth version: BT 5.0 Bluetooth frequency: 2.4G Hz
Bluetooth audio decoding format: SBC
Bluetooth distance: 360° in all directions up to 15m (close-fitting test without break)
Sensitivity: 105dBSPL +/-3dB @1KHz/1mW
Operation mode: BT/BT
Speaker unit: 13mm*2, Mic: MEMS
Battery capacity: single earphone 40mAh, charging box 500mAh
Playback time: 3 hours for listening to music, 30 hours for total listening time
Charging time: 30 minutes
Waterproof grade: IP6X
Product weight: 4.9g for single earphone, 60g for charging box
GT100 Bluetooth earphone is compatible with Android and iOS system. In order to enhance your experience,
please use the cellphone to scan the following QR code before your operation, or search for "Goodlark" in
major application markets to download and install APP.
Product instructions
打开盖板，指示灯会闪烁
1. Pair the earphone with the cellphone, follow the steps below
1) Open the charging box, turn on the Bluetooth function of the cellphone, search for the Bluetooth
device Goodlark-GT100, and then click to connecting.
2) When the prompt tone“Goodlark”come from the earphone, the pairing mode has been connected.
Note: When using the single ear for the first time, remove the right side earphone from the charging box
and close the charging box cover, then pair it. (The left side earphone does not need to be paired)
2. Insert into the ear canal
Insert earplugs into your ears and rotate them to fit into your ear canal
Removing the any side of
earphone will be paused, and
then put on will continue to play
music.
3. Fingertip wake up
The left side earphone double-click to wake-up function, the user can set up the specific content of wake-up
on the APP side, the Android cellphone is defaults to Goodlark APP wake-up, and the Apple cellphone is
defaults to siri wake-up.
4. Music play mode
When you put on your earphones, the cellphone music APP is playing status.
Play/pause music: put-on/remove any earphone
Play the next song: double-click on the right side earphone
5. Calling mode
Operate on either side of the earphone, double-click to call, and double-click to hang up
Double-click to play the next song, Click to wake-up the Goodlark
double-click to answer the call, double-click to answer the call,
double-click to hang up double-click to hang up
single earphone used
music play mode
Play/pause music:put-on/remove earphone
Play next song: double-click earphone
Calling mode
answer/hang-up the phone: double-click earphone
other mode
wake-up Goodlark/siri :double-click earphone
return connecting and re-charging
Open the charging box cover, put in the headset, automatically charge and back to the phone
The Bluetooth power
Bar is displayed at the
top of the phone as a
return success
Orange lighting reminds
charging box is low power
After two headphones are placed in the storage box and covered with a cover, the two lights flashing on the left
are identified as starting into charging mode orange lights are considered low power
other else notice
When connecting with a new device, ignore this device on the original device upon general-Bluetooth
announcements of attention
Do not place this headset in the position of the airbag in the car, which can cause serious damage when the
airbag pops up
Do not let children play with this headset, small parts will be another child's risk of suffocation
Where flammable, blasting points or potential explosive environments may require users to turn off electronic
equipment and radio devices, please be aware of the instructions when entering a specific range.
Please turn off the headset before boarding and do not use this headset in the aircraft
To protect your hearing, do not turn the volume too large
Do not use this product for long periods of time in wet environments and rain
maintainance
Turn off the headset before putting the headset in your pocket or handbag
Do not use a dissolved detergent to clean the headset
Do not allow headphones to receive direct sunlight for long periods of time
Do not dispose of headphones in the fire, which can cause an explosion
Do not let the headset touch sharp objects, which can cause scratches and wear
Do not attempt to disassemble the headset because it does not contain any repair components
When not using headphones for long periods of time, keep them in a cool, dry place to avoid extreme
temperatures and dust
Charge the headset at least once a month to extend battery life
Avoid charging the headset where the temperature is too high or too low.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Brand owner: Shenzhen Lark Acoustics
Consumer services hot line :4008387288
网址：http://www.goodlark.com.cn
Loading...