The CDW- N37632U-A0 is a highly integrated single chip which has built in a 2x2 dual-band wireless LAN
radio and Bluetooth radio.It supports IEEE 802.11a/b/g/n standard and provides the highest PHY rate up to
300Mbps, offering feature-rich wireless connectivity and reliable throughput from an extended distance.It
includes Bluetooth EDR and LE radio which complies with Bluetooth v2.1+EDR,v3.0,and v4.0+BLE.
Optimzed RF architecture and baseband algorithms provide superb performance and low power
consumption.
The CDW-N37632U-A0 integrates PA/LNA such that the number of the external components is reduced
to minimum.Intelligent MAC design deploys a high efficient DMA engine and hardware data processing
accelerators which offloads the host processor.
The CDW- N37632U-A0 supports the 802.11i security standard and implements hardware acceleration
for TKIP,CCMP and WAPI. The device also supports 802.11e Qos for video,voice,and multimedia
applications.
The CDW-N37632U-A0 can provide a comcurrent operation of Wi-Fi and Bluetooth over USB interace. An
intelligent Wi-Fi/Bluetooth coexistence algorithm is implemented to reach the best Wi-Fi and Bluetooth radio
performance.CDW-N37632U-A0 also features the high-speed UART with SIG standard HCI interface to
suppout Bluetooth over UART.
Bluetooth page scan+inquiry scan
(Page scan interval=1.28s,inquiry scan interval=2.56s)
2
mA
Bluetooth page scan
(Page scan interval=1.28s)
2
mA
5. Current consumption
5.1 WLAN current consumption
Note:All result is measured at the antenna port and VDD33 is 3.3V
5.2 Bluetooth current consumption
Note:All result is measured at the antenna port and VDD33 is 3.3V
http://www.cdtech.cn 9
Page 10
Cdtech CDW.N37632U-A0 WIFI module spec
6.
Dimension&Pin Assignments
http://www.cdtech.cn 10
Page 11
Cdtech CDW.N37632U-A0 WIFI module spec
NO.
Nam
Description
1
WF_WAKE
Wifi wake
2
LED
Led connection
3
GND
Ground connection
4
UDP
USB positive differential data lines
5
UDM
USB negative differential data lines
6
3.3V
Power supply 3.3V is required
7
RST
Reset
8
BT_WAKE
Blue tooth wake
9
GND
Ground connection
10
WF-RF1
WIFI-RF signal one
11
GND
Ground connection
12
GND
Ground connection
13
WF-RF0
WIFI-RF signal zero
14
GND
Ground connection
http://www.cdtech.cn11
Page 12
Cdtech CDW.N37632U-A0 WIFI module spec
7 Module Photo
7.1 PCBA physical photo
7.2 Crystal photo:
http://www.cdtech.cn 12
Page 13
Cdtech CDW.N37632U-A0 WIFI module spec
8
. Recommended Reflow Profile
Referred to IPC/JEDEC standard.
Peak Temperature : <250°C
Number of times : 2 times
http://www.cdtech.cn13
Page 14
Packing information
每盘装1800pcs,
前后各空20pcs
后面
空20pcs
外箱K=A:
36.4*35.7*37.5cm
5个啤盒
真空包装后
装入啤盒内
啤盒K3K:
33.5cm*34.7cm*7cm
1.每盘编带装机1800pcs(前后空20格不装产品)
2.编带完成后进行真空包装。
3.真空包装后,将编带装入啤盒内(共1800pcs)
4.每个外箱装5个啤盒,共装机:
1800pcs*5=9000pcs
啤盒
9.
Cdtech CDW.N37632U-A0 WIFI module spec
Remarks:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority
to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates,
http://www.cdtech.cn14
Page 15
Cdtech CDW.N37632U-A0 WIFI module spec
uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
"This equipment complies with FCC RF radiation exposure limits set forth
for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance
of 20 centimeters between the radiator and your body."
This module is designed to comply with the FCC statement, FCC ID is: 2A
M4L1.
The host system using this module, should have label in a visible area
indicated the following texts:
"Contains FCC ID: 2AM4L1".
ESD
CAUTION
The CDW-N37632U-A0 is ESD (electrostatic discharge) sensitive device and may be damaged
with ESD or spike voltage. Although CDW-N37632U-A0 is with built-in ESD protection circuitry,
please handle with care to avoid the permanent malfunction or the performance degradation.
http://www.cdtech.cn15
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.