ST DR+/ST TRIM+
POWER
TH DR+/TH TRIM+
LED
3CH
REV
STEERING WHEEL
THROTTLE TRIGGER
FCC ID: 2ARE7-91803
ST TRIM+
TH TRIM+
Please don' t reserve the battery,
or it will burn out the PCB
REV:
1.Please turn the wheel to left or right with Max angle , and press REV for 2 seconds, then ST will be reverse
2.Please pull the throttle or push the throttle to Max position , and press REC for 2 seconds, then REV will be
reverse
DR:
1.Please turn the wheel to left or right with Max angle, and press ST-TRIM+ or ST-TRIM-, then adjust the
angle of ST
2.Please pull the throttle or push the throttle to Max position, and press TH-TRIM+ or TH-TRIM-, then adjust
the angle of TH
This device complies with Par t 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference receive d, including interference that may cause undes i red operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the F CC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equip ment generates, uses
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does caus e
harmful interference to radio or television reception, wh ich can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Loading...