REMOTE CONTROL
1. Open the battery cover.
2. Insert two "AAA" size batteries (supplied with the product).
Place the batteries with their terminals corresponding to the (+)
and (-) indications in the battery compartment.
3. Close the battery cover
Caution
Incorrect installation may cause battery leakage and corrosion,
resulting in damage to the remote control.
• Do not mix old and new batteries.
• Do not mix different battery types (such as alkaline and
magnesium batteries).
• Do not use rechargeable batteries.
Do not burn or break batteries.
Voice Remote with Google Assistant
1
Remote Pairing
• Once you’ve connected your devices to
your television and plugged it in, insert
the included AAA batteries into the back
of the remote and press the “power”
button on the remote. Your television will
start and after press and hold the
button on your remote for 10 seconds you
will be prompted to pair your remote with
your television. Pairing your remote to
your television is necessary because the
remote uses Bluetooth to send most button
commands and voice commands to your
television.
• If your television doesn’t nd your remote,
remove and reinsert the batteries in your
remote. If your remote doesn’t pair with
your TV press and hold the button on
your remote for 10 seconds while your
television is searching for your remote.
• Once you’ve paired your remote, follow the
on-screen instructions to set up your TV.
2
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Changes or not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio technician for help.
FCC Radiation Exposure Statement
(3) The device has been evaluated to meet general RF exposure requirement. The devicecan be used
The device has been evaluated to meet general RF exposure requirement. The devicecan be used
in portable exposure condition without restriction.
cause harmful interference to radio communications. However,
For customer support: 1-888-338-5666
Please send all correspondence to:
Element TV Company, LP. Customer Service
customerservice@elementelectronics.com
www.elementelectronics.com
3
Loading...