SHENGZHEN MAYA ELECTRONICS CREATION MYA006 User Manual
MYA006
Parameter
( THD=10% ) 1 2W
20Hz~20KHz
3 3W
3 7V 400mAh Li-polymer battery
DC 5V 400mAM
OD 26” X H 27 5” (OD 66mm X H 70mm)
Package Contents
MYA006
3.5 mm Aux-In Cable
Warranty card
Function Indication Drawing
Short press:
press:
press:
press:
Operation Specification
Operation the MYA006
-
Slide the On/Off switch to the "On" posion, the Blue LED will flash. When the
Green LED is on, the unit is in Bluetooth Pairing Mode.
-Slide the On/Off switch to the "Off" posion, all the LED status lights will shut off.
Bluetooth Mode
-The unit will automacally go into “Pairing Mode” when it is turned on.
Aux-In Mode
Plug in the supplied 3.5 mm cable into the MYA006. The other end is connected
to the device.
*Please note that only “Volume +/-” will funcon on t
not funcon when in Aux-In mode.
Charging
-Aach the USB cable to the
is completely discharged, it take approximately 2.5 hours to fully charge the unit.
LED Status
Red LED: On- Charging/ Off– Charging complete
Green LED: On-BT Mode
Blue LED: Flashing-Pairing Mode/ Slow Flash-Connected
Powering On
Powering Off
Pairing
- Go into your devices sengs menu and look for “MYA006 ”
-If prompted for a password enter: 0000
-Aer the unit has paired, a
when
MYA006 is turned on and the device is in range.
-If no device is found aer 25 sec. the MYA006 will automacally enter
pairing mode.
Streaming Music
- Press “ ” to start playing music
- Press “+” to play the next track
- Press “ -” to play previous track
- Press and Hold either “+/-” for volume
nd connected it will connect automacally
he unit. Track control does
MYA006, and plug in to any USB charger. If the unit
Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC RF warning statement: The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition without restriction.
Loading...