Sharper Image Rechargeable Heated Glove Liners User Manual

WIRELESS RECHARGEABLE WARMING GLOVE LINERS

Item No. 206948

User Guide

Thank you for purchasing the Sharper Image Wireless Rechargeable Warming Glove Liners.
Please take a moment to read this guide and store it for future reference.

-1-

FEATURES

• Wireless rechargeable warming glove liners with single zone adjustable temperature control:
(5-Minute Pre-Heat, High, Medium and Low)

• Operates on rechargeable lithium-ion batteries (2pcs 2600mAh single cell batteries)

• Includes AC adapter

HOW TO USE

1. Plug the AC adapter into an outlet.

2. Connect 2pcs batteries to the AC adapter until it is fully charged. The AC adapter will display
a green light when it is fully charged and a red light while it is charging. There are two
indicator lights for both batteries. Note: Do not force the plug into the battery.

3. The red LED light on the AC adapter indicates that it is being charged.

4. When the green indicator light on the AC adapter lights up it means that the battery is fully
charged. Note: Fully charge the Wireless Rechargeable Warming Glove Liners battery before

using for the first time. Failure to fully charge the battery prior to the first use may reduce
battery life.

5. When fully charged, disconnect the battery plug from the AC adapter.

6. Locate the input plugs inside the small pouch in the cuff of each glove and connect the
charged battery. Place the battery into the pouch once connected.

7. Press and hold the control button in the glove for three to five seconds, or until the LED light
flashes red (Pre-Heat). Pressing it again will result in a red light (High). An additional press
will result in a white light (Medium). Another press will result in a blue light (Low) and will
then cycle through from the initial heat setting.

8. The LED light on the control button of the glove will flash red indicating that it is in Pre-Heat
mode.

9. After approximately five minutes the light will change to solid white, indicating that the glove
is no longer in Pre-Heat mode. The temperature can be adjusted by pressing the control
button.

10. To turn off the glove press and hold the control button for three to five seconds, or until the
LED light turns off.

11. Unplug the battery when the glove is not in use. Store battery inside the pouch of the glove
when temporarily not in use. Note: The Wireless Rechargeable Warming Glove Liners should

only be used with the included battery and charging cable.

TEMPERATURE SETTINGS

Red - High heat: 115º F with approximate run time of 2.5 hours

White - Medium heat: 107º F with approximate run time of 4.1 hours

Blue - Low heat: Average 103º F with approximate run time of 7 hours

Note: Above results are tested under an average room temperature of 82.4 Fº

-2-