Sharper Image Heated Slipper Socks User Manual

HEATED SLIPPER SOCKS

Item No. 207021

User Guide

Thank you for purchasing Sharper Image Heated Slipper Socks. Please read this guide and
store it for future reference.

-1-

FEATURES

• Heated Slipper Socks with single zone adjustable temperature control: (5-Minute Pre-Heat, High,

Medium and Low)

• Operates on rechargeable lithium-ion batteries (2pcs 2600mAh single cell batteries)

• Includes AC adapter

HOW TO USE

1. Plug the AC adapter into an outlet.

2. Connect 2pcs batteries to the AC adapter plugs of the battery charger until it is fully charged.

The indicator will light up green when it is fully charged and light up red while charging. There are

two indicator lights for both batteries. Note: Do not force the plug into the battery.

3. The LED light on the AC adapter’s red light indicates that it is being charged.

4. When the green light on the AC adapter lights up, the battery is fully charged. Note: Fully charge

the Heated Slipper Socks battery before using for the first time. Failure to fully charge the

battery prior to first use may reduce battery life.

5. When fully charged, disconnect the battery plug from the AC adapter.

6. Locate the input plugs inside the small pouch in the cuff of each slipper sock and connect the

charged battery. Place the battery into the pouch once connected.

7. Press and hold the control button in the slipper sock for three to five seconds or until the LED

light flashes red (5-Minute Pre-Heat). Pressing it again will result in a red light (High). An

additional press will result in a white light (Medium). Another press will result in a blue light (Low)

and will then cycle through from the initial heat setting.

8. The LED light on the control button of the slipper sock will flash red indicating that it is in Pre-

Heat mode.

9. After approximately five minutes the light will change to solid white, indicating that the slipper

sock is no longer in Pre-Heat mode. The temperature can be adjusted by pressing the control

button.

10. To turn off the slipper socks press and hold the control button for three to five seconds, or until

the LED light turns off.

11. Unplug the battery when the slipper socks are not in use. Store battery inside the pouch of the

slipper socks when temporarily not in use. Note: The Heated Slipper Socks should only be used

with the included battery and charging cable.

TEMPERATURE SETTINGS

• Red - High heat: Average 140º F with approximate run time of 2.3 hours

• White - Medium heat: Average 120º F with approximate run time of 3.8 hours

• Blue - Low heat: Average 95º F with approximate run time of 8 hours

Note: Above results are tested under an average room temperature of 82.4º F

-2-