Sharper Image Heated Base Layer 206950 User Manual

HEATED BASE LAYER

Item No. 206950

User Guide

Thank you for purchasing the Sharper Image Heated Base Layer. Please take a moment to read this guide and store it for future reference.

-1-

FEATURES

• Moisture-wicking long sleeve ﬁtted shirt

• Heated technology (chest, back, arms and wrists)

• Wrist cuﬀs with thumb holes

• Four heat levels: High, Medium, Low and Smart Pre-Heat

• Machine washable

• Lightweight

• Available in Small, Medium, Large and X-Large

• Front of shirt made of polyester and spandex

• Back of shirt made of polyester, cotton and spandex

• 6-hour continuous run time

• Runs on 3 rechargeable lithium-ion batteries

• Includes a USB charging cable and AC adapter

HOW TO USE

• Plug the AC adapter into an outlet.

• Connect the rechargeable batteries to the battery connect wire until it is fully charged.

• The red light will illuminate while charging. When it is fully charged the light will turn green.

Note: Do not force the plug into the battery. Connect all 3 batteries with the wire when charging. Fully charge the Heated Base Layer battery before using for the ﬁrst time. Failure to fully charge the battery prior to the ﬁrst use may reduce battery life.

• When fully charged, disconnect the batteries from the charger and wire.

• Locate the input plugs inside the small pouches in the Heated Base Layer and connect the charged battery.

• Place the batteries into the pouch once connected. There are two pouches, one the left side and one pouch on the right side.

• Press and hold the control button in the Heated Base Layer to cycle through heat levels. Press and hold for three to ﬁve seconds or until the LED light ﬂashes red to enter Pre-heat mode.

Note: Pre-heat is a battery saving mode. It occurs for the ﬁrst ﬁve minutes of use and then automatically changes to medium heat to preserve battery life. You can bypass the Pre-heat level by pressing the button again.

• After approximately ﬁve minutes the light will change to solid white, indicating the Heated Base Layer is no longer in Pre-heat mode. The temperature can be adjusted by pressing the control button to cycle through high, medium and low.

TEMPERATURE SETTINGS

• Red- High heat: Average 102º F with approximate run time of 2.8 hours

-2-

+ 3 hidden pages