Instruction Manual and
Warranty Information
EV-FAN44T
Flat Panel Tower Fan
THE SHARPER IMAGE® name and logo are registered trademarks. Marketed and distributed by
SI Products, LLC under license. ©The Sharper Image. All Rights Reserved.
IB-EVFAN44T
SI Products
Service Center
1.888.856.6781
8:30a.m. – 7:00p.m. (EST)
M – F
Mail To: SI Products
Return Center
43155 W. Nine Mile Road
Suite 3
Novi, MI 48375
e-mail:
cservice@siproducts.com
ONE YEAR LIMITED WARRANTY
SI PRODUCTS sells its products with the intent that they are free of defects in manufacture and
workmanship for a period of one year from the date of original purchase, except as noted below.
SI PRODUCTS warrants that its products will be free of defects in material and workmanship under
normal use and service. This warranty extends only to consumers and does not extend to Retailers.
To obtain warranty service on your SI PRODUCTS product, mail the product and your dated sales receipt
(as proof of purchase), postpaid, to the following address:
SI PRODUCTS
Return Center
43155 W. Nine Mile Road Suite 3
Novi, MI 48375
No COD's will be accepted.
SI PRODUCTS does not authorize anyone, including, but not limited to, Retailers, the subsequent
consumer purchaser of the product from a Retailer or remote purchasers, to obligate SI PRODUCTS in any
way beyond the terms set forth herein. This warranty does not cover damage caused by misuse or abuse;
accident; the attachment of any unauthorized accessory; alteration to the product; improper installation;
unauthorized repairs or modifications; improper use of electrical/power supply; loss of power; dropped
product; malfunction or damage of an operating part from failure to provide manufacturer’s recommended
maintenance; transportation damage; theft; neglect; vandalism; or environmental conditions; loss of use
during the period the product is at a repair facility or otherwise awaiting parts or repair; or any other
conditions whatsoever that are beyond the control of SI PRODUCTS.
This warranty is effective only if the product is purchased and operated in the country in which the
product is purchased. A product that requires modifications or adoption to enable it to operate in any
other country than the country for which it was designed, manufactured, approved and/or authorized, or
repair of products damaged by these modifications is not covered under this warranty.
THE WARRANTY PROVIDED HEREIN SHALL BE THE SOLE AND EXCLUSIVE WARRANTY. THERE
SHALL BE NO OTHER WARRANTIES EXPRESS OR IMPLIED INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS OR ANY OTHER OBLIGATION ON THE PART OF THE COMPANY WITH
RESPECT TO PRODUCTS COVERED BY THIS WARRANTY. SI PRODUCTS SHALL HAVE NO LIABILITY FOR
ANY INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES. IN NO EVENT SHALL THIS WARRANTY
REQUIRE MORE THAN THE REPAIR OR REPLACEMENT OF ANY PART OR PARTS WHICH ARE FOUND TO BE
DEFECTIVE WITHIN THE EFFECTIVE PERIOD OF THE WARRANTY.
NO REFUNDS WILL BE GIVEN. IF REPLACEMENT PARTS FOR DEFECTIVE MATERIALS ARE NOT AVAILABLE,
SI PRODUCTS RESERVES THE RIGHT TO MAKE PRODUCT SUBSTITUTIONS IN LIEU
OF REPAIR OR REPLACEMENT.
This warranty does not extend to the purchase of opened, used, repaired, repackaged and/or resealed
products, including but not limited to sale of such products on Internet auction sites and/or sales of such
products by surplus or bulk resellers. Any and all warranties or guarantees shall immediately cease and
terminate as to any products or parts thereof which are repaired, replaced, altered, or modified, without
the prior express and written consent of SI PRODUCTS.
This warranty provides you with specific legal rights. You may have additional rights which may vary from
state to state. Because of individual regulations, some of the above limitations and exclusions may not
apply to you. For more information regarding our product line in the USA,
please visit: www.siproducts.com
2 3
Triple performance and ultra slim profile in one fan.
Thank you for purchasing The Sharper Image® Flat Panel Tower Fan. This product,
along with entire The Sharper Image collection, connects innovation with cutting-edge
design to provide you with years of dependability and enjoyment. The stunning Flat
Panel Tower Fan features three fans, three speeds and three wind modes providing
the ultimate in customized comfort. Perfect for any room at home or in the office.
IMPORTANT SAFEGUARDS
WHEN USING ELECTRICAL PRODUCTS, ESPECIALLY WHEN
CHILDREN ARE PRESENT, BASIC SAFETY PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING
DANGER- TO REDUCE THE RISK OF ELECTROCUTION:
• Always unplug the appliance from the electrical outlet immediately after using
and before cleaning.
• DO NOT reach for an appliance that has fallen into water. Unplug it
immediately.
• DO NOT use while bathing or in shower.
• DO NOT place or store appliance where it can fall or be pulled into a tub
or sink.
• DO NOT place in or drop into water or other liquid.
WARNING
- TO REDUCE THE RISK OF BURNS,
ELECTROCUTION, FIRE OR INJURY TO PERSONS:
• An appliance should never be left unattended when plugged
in. Unplug from outlet when not in use and before putting on
or taking off parts or attachments.
• Close supervision is necessary when this appliance is used
by, on or near children, invalids or disabled persons.
• Use this appliance only for its intended use as described in
this manual. Do not use attachments not recommended by
The Sharper Image; specifically any attachments not provided
with the unit.
• NEVER operate this appliance if it has a damaged cord or
plug, if it is not working properly, if it has been dropped or
damaged, or dropped into water. Return it to SI Products
Service Center for examination and repair.
• Keep cord away from heated surfaces.
• NEVER drop or insert any object into any opening.
• DO NOT operate where aerosol (spray) products are being
used or where oxygen is being administered.
• DO NOT operate under a blanket or pillow. Excessive heating
can occur and cause fire, electrocution or injury to persons.
• DO NOT run cord under carpeting. DO NOT cover cord with
throw rugs, runners or similar coverings. Arrange cord away
from traffic area and where it will not be tripped over.
• DO NOT carry this appliance by the power cord or use cord
as handle.
• To disconnect, turn all controls to the “off” position, then
remove plug from outlet.
• This appliance is designed for personal, non-professional use
only.
Caution: All
servicing of
this product
must be
performed
by
authorized
SI Products
Service
Personnel
only.
4 5
• DO NOT use this fan with any solid-state speed control device.
• DO NOT expose to water or rain.
• DO NOT use outdoors.
READ AND SAVE THESE INSTRUCTIONS
Caution – Please read all instructions carefully before operating.
• Never leave the appliance unattended, especially if children are present.
• Never cover the appliance when it is in operation.
• Always keep the cord away from high temperature and fire.
• Unplug the fan from any outlet before cleaning.
• If the cord sustains damage, you must stop using this product immediately and
contact SI Products Service Center. (See the warranty section)
Technical specifications
Input voltage 110V
Rated Frequency 60Hz
Output power 90Watts
Weight 9.5 lbs
Noise level <55dB
Unit height 44 inches
Oscillation 90 degrees side to side
Remote Control Battery CR2032 3V
Main Features on Flat Panel Tower Fan
Touch Screen Control Panel
Touch Screen
Controls
Fan 1
Fan 2
Fan 3
Stand Pole
Base
Fig. 1
6 7
Assembly Instructions
Fig. 2
Fig. 3
Insert the bottom of stand pole into the center hole of the base. Lock it into place
by screwing on the nut. Make sure the nut it is completely tightened.
Operating Instructions
Power
ON/OFF
Wind Modes
Selection
Oscillation
ON/OFF
Speed
Selection
Fans
Selection
Timer
Selection
Timer
Settings
Speed
Settings
Oscillation
Indicator
Wind Mode
Settings
Stand Pole
Base
Nut
8 9
starting on High Breeze for 30 minutes, then shifting to Medium Breeze for
another 30 minutes and then shifting to Low Breeze. If the timer is set, then
the fan will automatically shut off at the selected time period. If the timer is not
on, then the fan will continue running in the Low Breeze mode until the fan is
turned off by pressing ON/OFF ( ) on the touch screen. While in this mode
SLEEP will show on the screen.
3. Oscillation
• To activate the oscillation, press OSCILLATE ( ) on the touch screen. The
fan will oscillate 90 degrees side to side. The oscillation symbol ( ) will light
up when the fan is oscillating.
• To turn off the oscillation, press OSCILLATE ( ). The oscillation
symbol ( ) will no longer be seen on the screen.
4. Operating the Three Fans
The Flat Panel Tower Fan offers you the ability to operate the fans individually or all
three together. Press FANS ( ) to switch between fans and make your desired
selection. Press once and all three fans will run. Press again, Fan 1 will run and
the other two will stop. Press again, Fan 2 will run and the other fans will stop.
Press again, Fan 3 will run and the other fans will stop. Press again and all three
fans will run. The appropriate FAN number will light up on the screen to indicate
which fans are running.
5. Timer
There are four possible timer settings: 30 minutes, 1 (one) hour, 2 (two) hours and
8 (eight) hours. To activate the timer and select a time setting, press
TIMER ( ) on the screen. Each time the TIMER ( ) function is pressed it
will switch between settings in a repeating cycle as follows: 30 minutes, 1 hour,
2 hours, 8 hours, OFF. Press again and the cycle begins again. The selection
will light up on the screen matching the time period. When the timer is OFF no
selections will be lit.
Using the Remote Control
• Check that neither the appliance nor the power cable has been damaged
when first using.
• Place the fan on a firm level surface.
• Plug the fan into a standard AC outlet. The fan will beep twice to confirm
connection.
• Press ON/OFF ( ) on the screen.
• NOTE: every time a command is pressed on the touch screen the fan will emit
a small beep and the appropriate symbol will light up confirming the function.
1. On/Off and Speed settings
• Turn the fan ON by pressing the ON/OFF ( ) symbol on the screen. The first
time it is turned on it will be operating as follows: LOW speed, NORMAL wind
mode, oscillation OFF and with all three fans running.
• If the unit has been used already, it will work as the settings the last time it was
used, except for the timer and sleeping mode functions.
• Once the fan is ON, press SPEED ( ) to select speed settings. The speeds
cycle as follows: Low Medium High. Each time SPEED ( ) is pressed.
The cycle repeats starting back at LOW.
• To turn the fan OFF, simply press ON/OFF ( ).
2. Wind Modes
• To select or change wind modes press MODE ( ) When first turned on
the fan starts in NATURAL mode. Press MODE once to change to BREEZE.
Press again to select SLEEP. Press again to return to NATURAL. The modes
repeatedly cycle as: NORMAL BREEZE SLEEP.
• NORMAL mode: In this mode, the fans operate in a standard continuous
pattern. The words BREEZE and SLEEP will not be lit on the screen.
• BREEZE mode: In this mode, the fan will alternate speeds from High to
Medium to Low, repeating regularly and automatically, this mode simulates a
natural breeze found outdoors. On the touch screen BREEZE will be lit.
• SLEEP mode: In this mode the fan will go into the BREEZE wind pattern,
10 11
Battery Installation
One CR2032 3V battery is included with the remote control. Remove the battery
drawer at the bottom back of the remote by squeezing the side and pulling the
drawer out. Please insert the battery into the remote with the positive side up as
shown on the drawer. If it is not going to be used for extended periods of time, we
recommend that you remove the battery out from the remote control and store it
in a safe dry place.
NOTE: Always keep the battery and remote control out of the reach of children.
Cleaning and Storage
Using the Remote Control
• Before you clean the fan, turn the fan OFF and unplug it.
• Use a dry cloth to clean the external surfaces of the fan.
DO NOT USE WATER, WAX, POLISH OR ANY CHEMICAL SOLUTION.
– Clean your fan using the above-mentioned steps, then pack the fan in its
original package and store in a cool dry place.
Fig. 5
Fig. 4
Speed Settings
Bottom of
Remote
Power ON/OFF
Wind Mode Selector
Oscillation ON/OFF
Timer Settings Timer Settings
Loading...