Sharper Image Battery Heated Gloves User Manual

BATTERY HEATED GLOVES

Item No. 206953

User Guide

Thank you for purchasing the Sharper Image Battery Heated Gloves. Please take a moment
to read this guide and store it for future reference.

-1-

FEATURES

• Battery heated gloves with single zone adjustable temperature control:
(5-Minute Pre-Heat, High, Medium and Low)

• Includes 2 rechargeable 3.7V batteries (one for each glove)

• Includes AC adapter

HOW TO USE

1. Plug the AC adapter into an outlet.

2. Connect 2pcs batteries to the AC adapter plugs of the battery charger until it is fully charged.
The indicator will light up green when it is fully charged and light up red while charging. There
are two indicator lights for both batteries. Note: Do not force the plug into the battery.

3. The LED light on the AC adapter’s red light indicates that it is being charged.

4. When the green light on the AC adapter lights up, the battery is fully charged. Charge time:

3.2 hours. Note: Fully charge the Battery Heated Gloves battery before using for the first

time. Failure to fully charge the battery prior to first use may reduce battery life.

5. When fully charged, disconnect the battery plug from the AC adapter.

6. Locate the input plugs inside the small pouch in the cuff of each glove and connect the
charged battery. Place the battery into the pouch once connected.

7. Press and hold the control button in the glove for three to five seconds or until the LED
light flashes red (5-Minute Pre-Heat). Pressing it again will result in a red light (High). An
additional press will result in a white light (Medium). Another press will result in a blue light
(Low) and will then cycle through from the initial heat setting.

8. The LED light on the control button of the glove will flash red indicating that it is in Pre-Heat
mode.

9. After approximately five minutes the light will change to solid white, indicating that the glove
is no longer in Pre-Heat mode. The temperature can be adjusted by pressing the control
button.

10. To turn off the glove press and hold the control button for three to five seconds, or until the
LED light turns off.

11. Unplug the battery when the glove is not in use. Store battery inside the pouch of the glove
when temporarily not in use. Note: The Battery Heated Gloves should only be used with the

included battery and charging cable.

TEMPERATURE SETTINGS

Red - High heat: Average 115º F with approximate run time of 2.5 hours

White - Medium heat: Average 107º F with approximate run time of 4.1 hours

Blue - Low heat: Average 103º F with approximate run time of 7 hours

Note: Above results are tested under an average room temperature of 82.4º F

-2-