Sharper Image 206169 Owner's Manual

NOISE CANCELLING BLUETOOTH HEADPHONES

Item No. 206169

Owner’s Guide

Thank you for choosing the Sharper Image Noise Cancelling Bluetooth Headphones.

Please take a moment to read this guide and store it for future reference.

FEATURES

• Bluetooth 4.1

• Noise cancelling technology

• Pairs easily with all iPhones, iPads, Samsung Galaxies and other Android devices

• Over 20 hours play time

• Built-in microphone for hands-free phone calls

• Includes airline adapter for wired use

• Includes travel pouch

HOW TO CHARGE THE HEADPHONE BATTERY

1. Open the rubber plug on the USB port.

2. Connect the USB port of your headphones with the USB port of your computer, USB
charger or etc. Use a suitable USB charging cable for this (type A plug to a type
micro B plug). The LED will pulse in white during the charging process.
The brightness of the LED indicates the charge status. The brighter the LED,
the higher the charge status. Once the battery is fully charged, the LED will illuminate
continuously in white.

3. Take the USB charging cable out of the USB port of the headphones and put
the rubber plug back in place. The LED will go out.

- 1 -

(

HOW TO CHARGE THE HEADPHONE BATTERY

NOTE: LED will flash in white and a signal tone will sound during low battery level in Bluetooth
mode. Before using the headphones, you must fully charge the battery and connect the headset
to your Bluetooth device. Charge time is 2.5 hours.

CONT’D)

BLUETOOTH PAIRING

Bluetooth mode only works if no cable has been connected. As soon as you connect the
headphones to a USB charger to charge or operate the headphones via a connector cord,
Bluetooth mode will automatically be deactivated. You can connect compatible devices such as
most smartphones with your headphones via Bluetooth. The audio output of your smartphone
is then emitted via Bluetooth.

1. Set the sliding switch to position B or C. The headphones will then be in pairing mode.
The LED will blink blue.

2. If the LED doesn’t blink blue, hold the MFB button down for 2 seconds. Pairing mode
will now be reactivated and the LED will blink blue.

3. Turn on the Bluetooth function on your device (e.g. smartphone).

4. Your smartphone will search for Bluetooth devices, and “SI Audio” should appear in
the detected devices list.

5. Select “SI Audio” from the list. If your device requires the entry of a PIN code, enter the
PIN code “0000” set by factory default. A signal tone will sound if the headphones and
your Bluetooth device are connected.

6. To terminate the Bluetooth® connection, switch off the Bluetooth function on your device.

HOW TO RECONNECT HEADPHONES

If your headphones have been previously connected with your smartphone, enabling the Bluetooth
function on your smartphone is all you have to do to connect the two devices.

HOW TO RESET HEADPHONES

To reset the Bluetooth pairing settings, move the sliding switch to position B or C. Hold down the
MFB and Vol - simultaneously for approximately 4 seconds. The LED will blink twice in blue and the
Bluetooth pairing settings will have been reset.

- 2 -