Sharper Image 205954 User Manual

20-SETTING BEARD AND STUBBLE TRIMMER

Item No. 205954

User Guide

Thank you for purchasing the Sharper Image 20-Setting Beard and Stubble Trimmer. Please
read this User’s Guide carefully and keep it for future reference.

- 1 -

FEATURES

1. Trimming Comb

2. Cutting Unit

3. Precision zoom
look adjustment
ring

4. ON/OFF switch

5. Socket for
appliance plug

6. Blade oil

7. Adapter

8. Cleaning brush

IMPORTANT SAFETY INSTRUCTIONS

When using an electrical appliance, basic
safety precautions should always be followed,
including the following. Read all instructions
before using this appliance.

TO CHARGE/ RECHARGE

Fully charge Trimmer before using for the first
time or after non-use for a long period of time.

Charging, recharging or using the Trimmer in
temperatures below 4°C (40° F) or higher than
35°C (95° F) adversely affects lifespan of the
battery.

• If the Trimmer is subjected to a major change
in temperature, pressure or humidity, let the
trimmer acclimatize for 30 minutes before
using.

• Continuously recharging Trimmer will reduce
lifespan of battery.

1. Be certain Trimmer is OFF (Fig.1).

2. Connect appliance plug directly into the
Trimmer (Fig.2) and plug adapter into any
220-240 V AC outlet. Note: Use only the

included adapter plug provided.

3. The charging light on the adapter lights up
RED to indicate the Trimmer is charging. After
fully charging, the charging light will remain
lit. It will take approximately 10 hours to fully
charge the Trimmer for a cordless trimming
time of up to 45 minutes.

4. Disconnect the cord and unplug from
electrical outlet.

To reduce the risk of electric shock:

1. Keep away from water.

2. Do not reach for a plugged in Trimmer that
has fallen into water. Unplug immediately.

3. The Trimmer is for dry use only. Do not use
while bathing or in a shower.

4. Do not place or store Trimmer where it can
fall or be pulled into a tub or sink.

5. Always unplug this Trimmer from the
electrical outlet immediately after (re)
charging.

6. Unplug and remove power supply cord from
Trimmer before cleaning.

OPTIMIZE THE WORKING LIFE OF THE
BATTERY

• After the Trimmer has been charged for
the first time, do not recharge the Trimmer
between trimming sessions. Continue using it
until the battery is completely empty.

• Do not charge for more than 24 hours.

• Do not keep cord permanently plugged in.

• Discharge / run down the battery completely
twice a year by letting the motor run until it
stops.

• If the Trimmer hasn’t been used for a long
period of time, it must be recharged for a full
10 hours.

- 1 -