Sharper Image 205234 User Manual

HEATED FOG-FREE SHOWER MIRROR

Item No. 205234

User Guide

Thank you for purchasing the Sharper Image Heated Fog-Free Shower Mirror. Please read these
instructions prior to using this device for the first time. In addition, please store this guide for
future reference.

- 1 -

FEATURES

• Heated glass

• Fog proof

• 1X & 3X magnification

• Stainless steel flex arm

• Chrome finish

• 6.5” dual-sided swivel mirror

• Adjustable razor hanger

• For men and women

PRODUCT PART IDENTIFICATION

HOW TO INSTALL THE HEATED FOG­FREE SHOWER MIRROR

1. Remove showerhead from shower
wall pipe. Turn showerhead connector
counter clockwise.

Note: Pliers may be required to loosen
the showerhead. If pliers are needed,
place a soft cloth between the pliers
and the showerhead connector to
prevent damaging the showerhead
connector surface.

2. Seal shower pipe threads. Apply several
turns of plumbing tape (not included) to
seal shower pipe threads.

Note: If this connection seems loose or
leaks after installing the shower mirror,
apply more tape to the connection.

HOW THE HEATED FOG-FREE SHOWER
MIRROR WORKS

When installed properly, a small amount
of water from your shower will circulate
through a copper coil embedded in the
shower mirror. As the water circulates
it warms the mirrors to the same
temperature as the shower water, making
it impossible for fog to form. The water
completes its circuit by traveling back up
through the flexible arm and out into the
shower stream.

3. Align plumbing connection. Carefully
align mirror plumbing connector with
the thread shower pipe.

4. Connect mirror. Rotate entire mirror
around shower wall pipe. The mirror
will rotate easily only if the plumbing
connector and shower wall pipe are
properly aligned.

Note: If the mirror tightens down and
comes to a final position that is not
desired, the addition of more plumbing
tape to the shower pipe threads will
influence the final, tightened down
position of the mirror.

5. Connect showerhead. Replace the
showerhead by screwing the showerhead
connector onto the threaded shower
mirror fitting.

- 2 -