Sharp Zaurus Quick Start Guide
Page 3
USB Driver Installation
and TCP/IP drivers are installed.
4. Follow the Wizard until both the Network
install the device.
will appear notifying you if you want to
“Add New Hardware Wizard” dialog box
3. Either “Found New Hardware Wizard” or
computer.
Station into the USB port of your
2. Plug the USB connector of the Docking
installation CD into your CD-ROM drive.
1. Turn on your PC and insert the Zaurus
insure that your PC finds your device.
On during this part of the installation to
Make sure that your Zaurus is Powered
7
7
Station
Docking
USB cable
Docking Station.
2. Connect the AC adapter to the
adapter.
1. Disconnect the Zaurus from the AC
Personal Information
Welcome Screen & Entering
AC adapter
cord
AC power
To AC outlet
USB connector
USB port
PC
your device.
installation to insure that your PC finds
is Powered On during this part of the
Important: Make sure that your Zaurus
Software.
You are now ready to install the Zaurus
key (Cancel key).
2. Turn On the Zaurus by pressing the On/Off
Docking Station
5500 and slide the Zaurus into the
1. Open the Sharp I/O Port cover of the SL-
6
6
Docking the Zaurus
AC adapter (EA-70)
Docking Station
To AC outlet
AC adapter jack
the Power to the
Zaurus & Connecting
Docking Station
5
5
Disconnecting the
Page 2
On/Off Key (Cancel Key).
7. Turn Off your Zaurus by holding down the
screen.
Information setup you will see the Home
6. When you are finished with the Personal
tap on the Finished button.
Start-up Guide for details.) When finished
Security purposes, enter a passcode. (See
5. If you want to enter a Passcode for
on the Next button.
your Personal Details. When finished tap
4. Using the keyboard of the Zaurus, enter
Next button.
information. When finished tap on the
entering the appropriate time zone
3. Set the System Time of the Zaurus by
hairs to calibrate the touch screen panel.
2. At the calibration screen, tap on the cross
the screen to go to the calibration screen.
1. After the Welcome screen appears, tap on
4
4
AC adapter jack
connector
AC adapter
cord
AC power
AC adapter
Charge the battery to its full capacity.
• If the battery level is low, the power will not turn on even if you attach the AC adapter.
5. Turn On the Zaurus by pressing the On/Off key (Cancel key).
4. The Amber LED will begin to glow indicating that the Zaurus is charging.
3. Plug the AC Power Cord into an AC Outlet.
2. Connect the AC adapter to the Zaurus.
1. Connect the AC Power Cord to the AC Adapter.
3
3
Connecting the Power
USB Driver Installation - Continued
8
8
1. When the USB installation is completed you will be asked to Reboot your PC.
Depending on the Windows® Operating system you are using, the following screen may
vary.
After rebooting your PC resume your installation by. “Installing the Synchronization
Software”
Install the Synchronization
9
9
Software
On the installation CD select - Step. 3 “Installing
the Synchronization Software”
NOTE: You may only install one synchronization
software program on your PC. If you try to
install both software programs you will get an
error.
If you are a Microsoft® Outlook® user click on
this Icon to install the software
If you Don’t use Outlook and want to install the
Qtopia Desktop Synchronization software click
this Icon to install the software.
When you are finished installing your
synchronization software you will be asked to
reboot your computer once again.
Congratulations!
10
10
You are now ready to use your Zaurus SL5500 and Synchronization Software. On
the other side of this Quick Start Guide
Sheet, there is information about how to
use your Zaurus and software.
Quick Start Guide - Read This First
Congratulations on your new purchase of the Sharp Zaurus SL-5500!
The Zaurus SL-5500 is a new exciting PDA from Sharp with exceptional Personal
Information Management, Mobile Communications and Mobile Multimedia tools.
You must prepare your Zaurus SL-5500 before you install your Zaurus software. Please
follow this Quick Start Guide, which will walk you through the installation of your Zaurus.
This Quick Start Guide is for experienced users of PC’s or handheld PDA’s and is not
intended to be used in place of the manuals supplied with your Zaurus. If at any time you
are not sure how to setup your Zaurus, please refer to the Start-up Guide and Operation
Manual the came with your Zaurus.
Opening the Battery
1
1
Compartment Lid
1. On the back of the Zaurus, slide the battery
replacement switch to the “REPLACE BATTERY”
position.
2. Gently slide replacement battery compartment lid
to the right and remove it from the Zaurus.
Install the Lithium Ion Battery
2
2
1. Insert the battery on the ribbon tab making sure
that the triangle, plus (+) and minus (-) signs on the
battery match the markings on the inside of the
Zaurus.
2. Replace the battery compartment lid with the
ribbon tab inside.
3. Slide the battery replacement switch to the
“NORMAL OPERATION” position.
4. When using the battery for the first time make sure
you charge the unit for 24 hours.
Page 1Page 4
PRINTED IN JAPANTINSE1281YCZZ
CF Card Slot
Headphone/Mic. Jack
IR Port
SD/Multimedia Card Slot
Application Menu
Alternate Input Menu
(Handwriting Recognition
and On Screen Keyboard)
Task Bar
Stylus
Navigation Tabs
Touch Screen
Volume
Installed Card Indicators
Time/Date
Num/Cap Lock
Keyboard
Special Symbols (FN + Space)
Home Key
(Switch Between Navigation
Tabs & Open Multiple Applications)
Quick Application Keys
(Can be customized in the Utility menu.)
Cancel Key
On/Off Key
(Press to turn On, Press and hold for 2 seconds to turn Off )
Main Navigation Tab Menus
Menu & Front Light On/Off
(Hold for 2 seconds to
Turn back light off.)
OK Key
AC adapter jack
SHARP I/O Port
Address Book
To quickly find a contact, just type
the first few letters on the keyboard.
©Copyright Sharp Electronics Corporation. All trademarks are the properties of their respective companies. For additional assistance with your Zaurus call 1-800-BE SHARP
Calendar
Switch to different views by
selecting the view tabs.
E-Mail
Sync or use optional modems to
View e-mails.
City Time
Select different time zones. The
calendar automatically updates times.
Media Player
Copy MP3’s and MPEG-1’s to your
Zaurus and create play lists.
Loading...