SHARP SP2060 Technical Report

Date: Nov. 5, 1996

COPIER : SF-2014

1.MEASURE TO IMPROVE PROBLEMS WITH CRACKING OF THE SPF HINGE.

2.CHANG E IN THE DIMENSIONS OF THE SPRING OF THE ROLLER RELEASE ARM IN THE PAPER FEEDER UNIT OF THE 250 CASSETTE.

1. Measure to improve problems with cracking of the SPF hinge.

1.Model Name: SN-1430 (only for machines bound for the U.S.A.)

2.General: Problems have occurred with cracking of the left and right SPF hinges due to load

stress on the springs and normal wear and tear which occurs with the passing of time. As a measure to alleviate this problem a reinforcement plate has been added as illustrated in the figure shown below.

No. : SP-2060

Old

Changed to

3.Action: ∗ Japanese production: From 1996 mid-June production.

Chinese (SOCC) production: From 1996 mid-June production. French (SMF) production: From 1996 June production.

2. Change in the dimensions of the spring of the roller release arm in the paper feeder unit of the 250 cassette.

1.Model Name: SF-2014/21 14/2214 SF-CM14 Z-800 (only for machines bound for Europe and the U.S.A.) SN-1420/1430 (only for machines bound for the U.S.A.)

New

Added reinforcement plate

SHARP CORPORATION Reprography Division

1/2

Green

2.General: Problems have occurred with the calling roller of the paper feeder unit in the 250 cassette failing to drop down low enough. As a measure to alleviate these problems a change in the dimensions of the spring of the roller release arm has been carried out as illustrated in the figure shown below.

Dimensions: 13.5 +

3.Action: From 1996 mid-July production.

Ref.

Model

No.

name

SN-1430

SF-2214 All

SN-1430

SF-2214 SF-2014

SF-2114 SF-2214

SN-1420 SN-1430

Z-800

Version P/G No.

U.S.A.

only

3-8

U.S.A.

only

3 -10

All

18 -28

U.S.A.

Europe

U.S.A.

only

17 -28

16 -28

Current parts New parts

Parts code Parts code

MHNG-0179FCZ3 MHNG-0179FCZ4 AT SPF hinge R

MHNG-0178FCZ3 MHNG-0178FCZ4 AU SPF hinge L

MSPRC2358FCZZ MSPRC2358FCZ1 AC

0.5 0 mm

↓ Changed to

14.1 ± 0.2mm

Price

rank

Parts name

Roller release arm spring

Effec-

tive

time

∗

Mid-

’96/7

Inter-

change-

ability

Note

2/2

SF-CM14 All

1. Interchangeable. 4. Not interchangeable.

2. C urr e nt t y pe c a n be u s ed i n p la ce of new ty pe . New ty pe cann ot be us ed i n place of curr ent type .

3. C urre nt ty pe cann ot be used i n place of new ty pe. New t y pe c a n be u sed in p lac e of c u r ren t ty p e.

Parts marked with “ ” is important for maintaining the safety of the set. Be sure to replace these parts with

specified ones for maintaining the safety and performance of the set.

52 -16

5. Interchangeable if replaced with same types of relate d parts in use .

6. Others.