SHARP SP1965 Technical Report
Date: Nov. 24 , 1995
COPIER : SF-2014
No. : SP-1965
MEASURES TO IMPROVE THE ORIGINAL
DOCUMENT STACKING PERFORMANCE WHEN
USING THE SPF.
1.Model name: SF-2214, SN-1430
2.General: The measures described below have been carried out to improve the original document
stacking performance when using the SPF.
3.Description: A delivery reinforcement sheet was added to the delivery roller. In accordance with the
addition of the delivery reinforcement sheet, the cut-away section has been enlarged to
prevent contact with the of the SPF cover. (Please refer to the figure.)
SPF Delivery roller
Attachment
surface
(Figure 1) (Figure 2)
.
The delivery reinforcement sheet is attached only to the center rubber roller. (It is
Hole for the SP pin
(φ 2.15)
OK
NG
Delivery reinforcement sheet
A
B
attached to the side of the roller furthest from the φ2.15 hole for the SP pin.)
.
The attachment surface of the roller should be cleaned with alcohol.
.
The delivery reinforcement sheet should be attached so that there is no space
between of the attachment standards A and B. (Please refer to Figure 2.)
.
The delivery reinforcement sheet should be attached as shown in Figure 2, without
allowing the slit to open, or without allowig the sheet to protrude from the rubber
section.
SHARP CORPORATION Reprography Division
1/2
Green
C
The delivery reinforcement sheet has been established as a single part, but the delivery
roller with the delivery reinforcement sheet attached has also been established as a
delivery roller AS part.
A Section detail.
Cut-away section is indicated by the diagonal lines.
(Figure 3).
4.Action: ∗ Japanese production: From the start of 1995 September production.
Chinese (SOCC) production: From the start of 1995 October production.
French (SMF) production: From the start of 1995 December production.
Ref.
Model
No.
SF-2214 All
SN-1430
SF-2214 All
1
SN-1430
SF-2214 All
SN-1430
<Interchange>
1. Intercha ng ea bl e. 4. N ot i nt erc h an ge ab l e.
2. Current type can be used in place of new type.
New type cannot be used in place of current type.
3. Current type cannot be used in place of new type.
New type can be used in place of current type.
Parts marked with “ ” is important for maintaining the safety of the set. Be sure to replace these parts with
speci fied ones fo r m aintaini ng t he s a fe ty an d pe rformance of the set .
name
Version P/G No.
U.S.A.
only
3
U.S.A.
only
U.S.A.
3-2
only
!
Current parts New parts
Parts code Parts code
PSHEZ4050FCZZ AE
—
CROLR1034FC01 AU
GCOVH0223FCZZ GCOVH0223FCZ1 AW SPF upper cover 3
Price
5. Interchangeable if replaced with same types of
relate d parts in use .
6. Ot hers.
Parts name
rank
Delivery
reinforcement
sheet
SPF delivery
roller
Effec-
tive
time
∗
Inter-
change-
ability
—
Note
2/2
Loading...