SHARP sp1937 Technical Report

COPIER : Z-30
Date
:
Oct. 9, 1995
No. : SP-1937
MEASURES TO PREVENT THE FUSING GEAR FROM BREAKING.
1.Model name: Z-30
2.General: Cases of the fusing gear breaking (split apart) sometimes occurred. To alleviate this
problem the following measures have been carried out.
3.Description: Most of the cases of broken gears occurred during the molding process at the
three-point gate when the plastic parts collided with the welded section of the gears. The following improvement measures have been carried out.
the drying conditions of the base materials used.
(2) By changing the three-point gate to a one-point gate the welding spots were reduced
to only one spot.
4.Action: Chinese (GE) production:From 1995 mid-June production.
Ref.
Model
No.
Z-30 All
<Interchange>
1. Interchangeable. 4. Not interchangeable.
2. Current type can be used in place of new type.
3. Current type cannot be used in place of new type.
Parts marked with ‘‘ ’’ is important for maintaining the safety of the set. Be sure to replace these parts with
specified ones for maintaining the safety and performance of the set.
Version P/G No.
name
9 -20
New type cannot be used in place of current type.
New type can be used in place of current type.
Current parts New parts
Parts code Parts code
NGERH0540FCZZ NGERH0540FCZ1 AE Fusing gear
Price
5. Interchangeable if replaced with same types of related parts in use.
6. Others.
Parts name
rank
Effec-
tive
time
Mid-
’95/6
Inter-
change-
ability
3
Note
SHARP CORPORATION Reprography Division
Green
C
Loading...