SHARP SP1752 Technical Report

Date: May. 10, 1994

COPIER : Z-20

1. TROUBLE SHOOTING PEELING OF THE OPERATION INSTRUCTION LABEL.

2. ST ANDARDI ZATION OF THE OPERATION LABEL DI MENSIONS.

1.Trouble shooting peeling of the operation instruction label.

1.Model name: Z-25/23

2.General: Each of the operation instruction labels for models Z-25/23 had a slit down the center of

the surface of the label, and when attaching the label was divided right and left, but the tail part of the attached surface of the left side of the label was rough, and would be prone to peeling due to the high heat involved during the fixing process beneath it. T o alleviate this problem, double sided tape had been applied to the back side of the labels to attach them, but as a permanent trouble shooting measure the following change has been carried out.

No. : SP-1752

3.Description: 1) The dimensions of the labels in each language (Japanese, English, and the labels printed in four (4) languages) have been standardized.

2) The labels have been divided into two labels, A and B . Label B has been made with material that is resistant to peeling, and the glue has been changed. The parts codes have also been changed in accordance with these changes.

Z-25 (bound for SUK)

(New)

(Discontinued) Operation instruction label U-UG TLABH3502FCAZ

Z-25 (bound for SEEG)

(Discontinued) Operation instruction label E4-UG TLABH3503FCAZ

Operation instruction label U-A TLABH3538FCAZ

Operation instruction label U-B TLABH3539FCAZ

(New) Operation instruction label E4-A TLABH3531FCAZ

Operation instruction label E4-B TLABH3535FCAZ

SHARP CORPORATION Reprography Division

1/3

Green