SHARP SP1738 Technical Report

Date: May. 10, 1994

COPIER : Z-85

No. : SP-1738

DISCONTINUANCE OF MYLAR SPACERS IN THE LOWER BASE PLATE UNIT TO IMPROVE PRODUCTIVITY.

1.Model name: Z-85/85 II

2.General: Mylar spacers had been attached to the lower base plate unit as a trouble shooting

measure to prevent rear end print transfer misalignments, but when mass production of model Z-88 was started, changes were carried out on the bearing of the pressure fixer roller as a trouble shooting measure for the same problem. The same trouble shooting measure was also carried out on the Z-85 series, and the mylar spacers were therefore unnecessary and discontinued.

3.Action: From 1994 March production.

Ref.

Model

No.

Z-85 Z-85II

1. Interc ha ng ea bl e. 4. Not int erc h an ge ab l e.

2. Current type can be used in place of new type. New type cannot be used in place of current type.

3. Current type cannot be used in place of new type. New type can be used in place of current type.

Parts marked with “ ” is important for maintaining the safety of the set. Be sure to replace these parts with

speci fied ones fo r m ai n ta ini ng t he s a fe ty an d pe r fo rma nc e o f the set .

name

Version P/G No.

All

Current parts New parts

PSHEP3221FCZZ — — Spacer mylar ’94/3 —

Parts code Parts code

Effec-

Price

5. Interchangeable if replaced with same types of relate d parts in use .

6. Others .

Parts name

rank

tive

time

Inter-

change-

ability

Note

SHARP CORPORATION Reprography Division

Green