SHARP S207 Technical Report

Date: Jun. 5, 1997
COPIER : SF-2050
MEASURE TO COMPLY W ITH EMI (ELECTRICAL NOISE) ST ANDARDS.
1.Model Name: SF-2050 (only for machines bound for the Taiwan market)
2.General: EMI (electrical noise) standards have been put in effect in Taiwan as of 1997 January.
In accordance with this market development, the changes described below have been carried out.
No. : S-207
1) A change in the high voltage transistor has been carried out, and the high voltage transistor for the 200 V series is now being used.
2) The main harness R with the ferrite core attached used for machines bound for the U.S.A. market has been changed to a main harness R with a new ferrite core attached to it.
3) The AC PWB has been changed to one with a new capacitor added to it. In accordance with this change the AC PWB has been changed to an AC PWB with a ferrite core attached to it.
4) A new AC cord unit has been established for machines bound for the Taiwan market.
5) The addition of a noise filter 2 unit has been carried out in compliance with the new standards. The noise filter 2 unit is attached by use of a binding band.
6) The addition of a CL coil unit has been carried out in compliance with the new standards. The CL coil unit is attached by use of a binding band.
3.Description: 2) Main harness R
Binding band
Ferrite core
6 Pin connector
10 Pin connector
SHARP CORPORATION Reprography Division
1/3
Green
C
3) AC PWB attachment plate
Attachment of the ferrite core
4) AC Cord unit
Pass through two times (2T) Ferrite core: RCORF1034LCZZ x 1
AC Cord: QACCD7415QCZZ *1
5) Noise filter 2 unit.
White harness
Connected to the AC PWB
Binding band: LBNDJ1001HCZZ *1
Black
White Green
Noise filter 2 unit: RFILN0027FCZZ *1
Changed housing: QCNCM0959FCZZ *1 Changed terminal: QTANP0205FCZZ *2
M4 round head screws: QTANP0176FCZZ *1
Ferrite core: RCORF1034LCZZ *1 Pass through two times (2T) (wrapped once)
Black harness Connected to the AC PWB
Connected to the AC cord
Attached to the main harness of the lower unit to secure the noise filter 2 unit.
2/3
6) CL Coil unit. The CL coil unit is connected between the 3 pin connector (copy lamp line) which is connected to the optical unit. Afterward, a snap band is used to secure it to the optical unit.
Connector from the main harness
LBNDJ0043FCZ1
RCILF0088FCZZ
Connector from the CL coil unit
Mirror motor
Connector from the CL coil unit
LBNDJ0013FCZ1
Care should be exercised to insure that the lead wire of the 3 pin connector which is connected to the optical unit does not come in contact with the mirror motor when securing it to the main harness.
Loading...
+ 1 hidden pages