SHARP S185 Technical Report
Date: Jan. 10, 1997
DUPLICATOR : SD-3062
No. : S-185
ESTABLISHMENT OF NEW STANDARDS FOR THE RDH UNIT.
1.Model Name: SD-3062 (only machines bound for Australia)
2.General: Trouble with miscounts of the original copies sometimes occurred when using the RDH.
As a measure to alleviate this problem, the following measure, described below, was
carried out.
Also, in accordance with this measure a new standard unit code has been established
for the RDH units used in machines bound for the Australian markets.
3.Description:
Figure-1
Transfer discharge paper mylar sheets.
Stacked three (3) per stack in two (2) locations.
Q’ty: 4 → 8
Figure-2
Plate R
(Discontinued)
Plate molt A/S part.
Figure-1: Improve the dropping performance of the copy paper by reinforcing the
transfer discharge paper mylar sheets.
Figure-2: By discontinuing the molt, the copy paper F/R droppi ng balance can be
established.
4.Action: From the start of 1996 September production.
SHARP CORPORATION Reprography Division
1/2
Green
C
Ref.
Model
No.
SD-3062
<Interchange>
1. Interchangeable. 4. Not interchangeable.
2. C urr e nt t y pe c a n be u s ed i n p la ce of new t y pe .
New ty pe cann ot be us ed i n place of curr ent type .
3. C urre nt ty pe cann ot be used i n place of new ty pe.
New t y pe c a n be u sed in p la c e of c u rr en t ty p e.
Parts marked with “ ” is important for maintaining the safety of the set. Be sure to replace these parts with
specified ones for maintaining the safety and performance of the set.
name
Version P/G No.
57 -901
SCA
59 -901
only
60 -901
!
Current parts New parts
Parts code Parts code
DUNT-6641FC13 DUNT-6614FC16 ES RDH unit — 3
Price
5. Interchangeable if replaced with same types of
relate d parts in use .
6. Others .
Parts name
rank
Effec-
tive
time
Inter-
change-
ability
Note
2/2
Loading...