SHARP S171 Technical Report

Date: Nov. 15, 1995

COPIER (OPTION): SF-S16

No. : S-171

COMPLIANCE WITH NOISE (CE-MARK) STANDARDS

1.Model name: SF-S16 (only for machines bound for SEEG and the UK).

2.General: When model SD-2060 is hooked up with the SF-S16 (20 pin sorter), there is a

possibility of the noise level not sufficiently meeting noise standards. To alleviate this problem, a grounding plate has been added to the SF-S16 in the location indicated in the figure shown below. In accordance with this change, a one-page explanation of installation procedures has also been added.

3.Action: From the start of 1995 July production.

SHARP CORPORATION Reprography Division

1/2

Green

Ref.

Model

No.

SF-S16

1. Interc ha ng ea bl e. 4. N ot i nt er ch an ge ab l e.

2. Current type can be used in place of new type. New type cannot be used in place of current type.

3. Current type cannot be used in place of new type. New type can be used in place of current type.

Parts marked with “ ” is important for maintaining the safety of the set. Be sure to replace these parts with speci fied ones fo r m ai n ta in ing the safe ty an d pe r fo rma nc e o f the set.

name

Version P/G No.

SEEG

4—

Current parts New parts

Parts code Parts code

0CW4050P074// AR CE earth plate

0CW4050P170// BB

5. Interchangeable if replaced with same types of

6. Others.

Price

relate d parts in use .

Parts name

rank

One-page explanation

H-CE

Effec-

tive

time

1st lot

’95/7

Inter-

change-

ability

—

Note

2/2