Sharp NS-F130G5 User Manual

1,000-VOLT SYSTEMS

130 WATT

FRAMELESS, GLASS-ON-GLASS THIN FILM MODULE

Amorphous Silicon/Microcrystalline Silicon IEC-Certiﬁed for 1,000-volt systems For Behind-the-Fence Applications

Sharp: The ﬁrst name in solar power. The last word in solar innovation.

Oering one of the most ecient thin ﬁlm photovoltaic products ever manufactured for multi-megawatt-scale power production.

ENGINEERING EXCELLENCE

Tandem-junction structure (amorphous silicon/ microcrystalline silicon) captures a wider part of the solar spectrum, converting more sunlight into electricity.

HIGH VOLTAGE ADVANTAGE

Proprietary design increases reliability by minimizing losses caused by module output variation.

RELIABLE

Microcrystalline layer provides superior long-term stability and higher module eciency.

warranty on power output.

25-year limited

NS-F130G5

THIN FILM PHOTOVOLTAICS: THE NEXT EVOLUTION OF SOLAR TECHNOLOGY

Sharp’s thin ﬁlm product pairs amorphous silicon with a layer of microcrystalline silicon to achieve high stability and performance. Produced with less than one percent of the silicon used in crystalline solar cells, thin ﬁlm products oer high performance with less semiconductor material. With a low temperature coecient for output power, thin ﬁlm generates greater energy than its crystalline silicon counterpart in geographic regions where temperatures are high. In warm climates, this translates into more kilowatthours per kilowatt. Certiﬁed to IEC 61646, these modules are for behind-the-fence applications.

DURABLE

Two glass layers laminated with a high performing vapor barrier encapsulant.

INNOVATIVE

The front glass has low iron content and the back is tempured for greater strength. The encapsulant has a low moisture vapor transmission which eliminates the need for an edge seal. Modules are sized to optimize the greatest amount of power.

1 MW thin ﬁlm installation in Munich Germany, April 2009

sHARp: THE NAmE TO TRUsT

When you choose Sharp, you get more than wellengineered products. You also get Sharp’s proven reliability, outstanding customer service and the assurance of our 25-year limited warranty on power output. A global leader in solar electricity, Sharp powers more homes and businesses than any other solar manufacturer worldwide.

BECOmE pOwERfUL

SHARP ELECTRONIC S CORPORATION

5700 NW Paciﬁ c Rim Boulevard, Camas, WA 98607

www.sharpusa.com/solar

130 WATT

NS-F130G5

Amorphous Silicon/Microcrystalline Silicon IEC-Certiﬁ ed for 1,000-volt systems (IEC 61646)

ELECTRICAL DATA

Maximum power Pmax

Tolerance of Pmax

Open-circuit voltage Voc

Short-circuit current Isc

Voltage at maximum power Vpmax

Current at maximum power Ipmax

Module e ciency

Temperature coe cient – open circuit voltage

Temperature coe cient – short circuit current

Temperature coe cient – power

MADE IN JAPAN

The electrical data applies under standard test conditions (STC): Irradiance of 1,000 W/m Output values are post initial Stabler-Wronski decay; actual measured initial values will be greater than nominal value (by approximately 15% for power).

spECIfICATIONs (I)

Cell Tandem architecture of amorphous and microcrystalline silicon

Dimensions 1001 x 1402 x 7.4 mm

Weight 26 kg

Front glass Low iron non-tempered glass

Back glass Tempered

Connection type Cable with SMK connector

NAmEpLATE VALUEs

Ns-f130G5

130 W

+7%/-2%

60.4 V

3.41 A

46.1 V

2.82 A

9.3%

-0.3%/°C

+0.07%/°C

-0.24%/°C

with an AM 1.5 spectrum at a cell temperature of 25º C.

EXTERIOR DImENsIONs

BACK VIEW SIDE VIEW

spECIfICATIONs (II)

Maximum system voltage 1,000 V

Maximum mechanical load 2,400 Pa

Series Fuse Rating 5 A

Operating temperature (cell) - 40 to +90 °C

Storage temperature - 40 to +90 °C

Storage air humidity Up to 90 %

Installation orientation Portrait or Landscape

Design and speciﬁ cations are subject to ch ange wit hout notice. Sharp i s a registe red trad emark of S harp Co rporation. All o ther tra demarks are prop erty of their respective owner s.

1001 mmB1402 mmC7.4 mmD950 mm

24 mm