Sharp LQ0B152 Datasheet

PREPARED BY : DATE

-1

I

1 SHARP

LIQUID CRYSTAL DISPLAY GROUP
SHARP CORPORATION

I

SPECIFICATION

DEVICE SPECIFICATION FOR

BACKLIGHT UNIT

MODEL No.

SPEC No. LD - 8706

FILE No.

ISSUE : August 28 . 1995

PAGE : 6 pages

APPLICABLE GROUP
Liquid Crystal Display
Group

0 CUSTOMER’S APPROVAL

DATE

BY

LQOB152

PRESENTED

H.FUKUOKA
Department General Manager
Engineering Department 2
TFT Development Center
TENRI LIQUID CRYSTAL
DISPLAY GROUP
SHARP CORPORATION

/

SHARP

(1) Subject

LQOB 152 : Literature on backlight unit for 35cm( 13.8”) TFI’-LCD module.

> These specification sheets are the proprietary product of SHARP CORPORATION

(SHARP) and include materials protected under copyright of SHARP. Do not

reproduce or cause any third party to reproduce them in any form or by any means,

electronic or mechanical, for any purpose, in whole or in part, without the express
written permission of SHARP.

> The device listed in these specification sheets was designed and manufactured for use

in OA equipment.

> In case of using the device for applications such as control and safety equipment for

transportation (aircraft, trains, automobiles, etc. ), rescue and security equipment and
various safety related equipment which require higher reliability and safety, take into

LD8706- 1

consideration that appropriate measures such as fail-safe functions and redundant
system design should be taken.

> Do not use the device for equipment that requires an extreme level of reliability, such

as aerospace applications, telecommunication equipment(trunk lines), nuclear power

control equipment and medical or other equipment for life support.

> SHARP assumes no responsibility for any damage resulting from the use of the

device which does not comply with the instructions and the precautions specified in
these specification sheets.

Contact and consult with a SHARP sales representative for any questions about this

device.

(2) Introduction

This backlight unit is a service part for 35cm TFT-LCD module (LQ14XOl)
whose backlight is designed to be replaceable.

(3) Construction and Outline

The unit is composed of cold cathode fluorescent tubes, rubber cushions,

I/O wires (including connectors), and lamp holders.

* Outline drawing of backlight unit

: See Fig. 1.

SHARI=

(4) Input / Output terminals

4-l) I/O terminal order

Table 1

Pm No. Symbol i/o Description

LD8706- 2

1
2
3

4-2) I/O connector

1) Installed socket housing : BHR-03VS-1

2) Applicable connector housing: SM02(8.O)B-BHS-1

(5) Electrical characteristics

VHIGH

NC

VLOW

i Power supply for lamp (High voltage side)

- No connection
i Power supply for lamp (Low voltage side)

( produced by Japan Solderless Terminal )

Table 2

Ta=25”C

[Note 1) Available current range considering light-adjustment.
[Note 2) Calculated value for reference

[Note 31 Lamp life terminates when the luminance under the rated power

reached 50% of the initial value after the continuous operation
under rated power and the room temperature.

(6) Optical characteristics

Table 3

Parameter

Luminance

Chromaticity X 0.261 0.291 0.321

[Note 31 The measurement shall be executed 15-20 minutes after lighting

Symbol MIN. TYP. MAX. Unit

YL

Y 0.241 0.271 0.301

attracted power.

The value measured at the center of the cold cathode fluorescent

tube at a viewing cone 0.1 ’ by TOPCON luminance meter BM-7.

26,000 cd/m2 (just for reference)

(IL X VL)

Remarks

[Note 31

Ta=25”C