Sharp HRO00163 FCC statements

73

付

録

／

索

引

In some countries/regions, such as France, there are restrictions on the use of Wi­Fi

®

. If you intend to use Wi-Fi® on the handset abroad, check the local laws and

regulations beforehand.

■Mobile Light

Do not point the illuminated light directly at someone’s eyes.

Do not use Mobile light near people’s faces. Eyesight may be temporarily
affected leading to accidents.

CAUTION:

Use of controls, adjustments or performance of procedure other than those
specified herein may result in hazardous radiation exposure. As the
emission level from Mobile light LED used in this product is harmful to the
eyes, do not attempt to disassemble the cabinet. Servicing is limited to
qualified servicing station only.

Mobile light source LED characteristics

a) Continuous illumination
b) Wavelength

White: 400-700 nm

c) Maximum output

White: 1.03mW (inside cell phone 3.43 mW)

■AC Adapter

Any AC adapter used with this handset must be suitably approved with a
5Vdc SELV output which meets limited power source requirements as
specified in EN/IEC 60950-1 clause 2.5.

■Battery - CAUTION

SafetyInformation

CEDeclarationofConformity

Hereby, Sharp Telecommunications of Europe Ltd, declares that this IS14SH is in
compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC.
A copy of the original declaration of conformity can be found at the following Internet
address:
http://www.sharp.co.jp/k-tai/

EN60825-1:1994 A1:2002 & A2:2001

CLASS1
LED Product

Mobile light

Use specified battery or Charger only.

Non-specified equipment use may cause malfunctions, electric shock or fire
due to battery leakage, overheating or bursting.

Do not dispose of an exhausted battery with ordinary refuse; always tape
over battery terminals before disposal. Take battery to an au Shop, or follow
the local disposal regulations.

Charge battery in ambient temperatures between 5°C and 35°C; outside
this range, battery may leak/overheat and performance may deteriorate.

KUUJAWDQQMࡍ࡯ࠫ㧞㧜㧝㧝ᐕ㧝㧝᦬㧝㧣ᣣޓᧁᦐᣣޓඦᓟ㧥ᤨ㧡㧜ಽ

74

付

録

／

索

引

■Loudness warning

Excessive sound pressure from earphones and headphones can cause
hearing loss.

■Headphone Signal Level

The maximum output voltage for the music player function, measured in
accordance with EN 50332-2, is 35 mV.

■European RF Exposure Information

Your mobile device is a radio transmitter and receiver. It is designed not to
exceed the limits for exposure to radio waves recommended by international
guidelines. These guidelines were developed by the independent scientific
organization ICNIRP and include safety margins designed to assure the
protection of all persons, regardless of age and health.
The guidelines use a unit of measurement known as the Specific Absorption

Rate, or SAR. The SAR limit for mobile devices is 2 W/kg and the highest

SAR value for this device when tested at the ear was 0.08 W/kg

※

.
As SAR is measured utilizing the devices highest transmitting power the
actual SAR of this device while operating is typically below that indicated
above. This is due to automatic changes to the power level of the device to
ensure it only uses the minimum level required to reach the network.
The World Health Organization has stated that present scientific information
does not indicate the need for any special precautions for the use of mobile
devices. They note that if you want to reduce your exposure then you can do
so by limiting the length of calls or using a hands-free device to keep the
mobile phone away from the head.

- This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may
cause undesired operation.

- Changes or modifications not expressly approved by the manufacturer
responsible for compliance could void the user's authority to operate the
equipment.

■Information to User

This equipment has been tested and found to comply with the limits of a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular
installation; if this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

1. Reorient/relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

※The tests are carried out in accordance with international guidelines for testing.

FCCNotice

KUUJAWDQQMࡍ࡯ࠫ㧞㧜㧝㧝ᐕ㧝㧝᦬㧞㧢ᣣޓ࿯ᦐᣣޓඦᓟ㧝㧞ᤨ㧠㧝ಽ