Sharp HRO00142, HRO00141 User Manual

EB-W51GJ Quick Tips

EB-WX1GJ

Charge the product

The product is not fully charged when you purchase it. Before using the product for the first time or when the battery has run low, charge the battery.

●Only use the specified AC adapter. Using an AC adapter other than the specified type may cause a fire or electric shock.

●If the product is not charged after the prescribed charging time has elapsed, stop charging. Continuing to charge the product may cause a fire or electric shock.

1.Insert the power plug of the AC adapter into a power socket.

2.Insert the connector of the AC adapter into the product's power/mini-USB connector.

Power/mini-USB connector

When charging starts, the battery indicator on the front side of the product () turns red. When the product is fully charged, the battery indicator turns off.

3.When charging is finished, remove the connector of the AC adapter.

4.Disconnect the AC adapter from the power socket.

1

Turn on/off the power

Turn on the power

1. Press the power key.

Rear side of product

Turn off the power

1. Hold down the power key for 2 seconds.

The menu is displayed.

2.Tap [ OFF].

3.Tap [OK].

Setup

STEP 1 : Configure wireless LAN settings

Register information about the access point you will use.

●Users are liable for communication and connection charges required when using the wireless LAN function.

●These instructions cover the configuration procedure for an access point using AOSS.

1.Turn on the power by pressing the power key.

2.Tap [ ].

3.Tap [AOSS ].

4.Tap [AOSS].

Press the AOSS button on the access point device (the wireless LAN base station).

5. When the [AOSS ] screen appears, tap [OK].

The [ ] screen appears.

2