Use only the battery packs and adapters specified by NTT DOCOMO for use
with the FOMA terminal.
May cause fires, burns, bodily injury or electric shock.
Do not throw the battery pack into a fire.
The battery pack may catch fire, explode, overheat or leak.
Do not dispose of used battery packs in ordinary garbage.
May cause fires or damage to the environment. Place tape over the terminals to
insulate unnecessary battery packs, and take them to a docomo Shop, retailer or
institution that handles used batteries in your area.
Avoid using the handset in extremely high or low temperatures.
Use the FOMA terminal within the range of a temperature between 5°C and 35°C
and a humidity between 45% and 85%.
Charge battery in areas where ambient temperature is between 5°C and
35°C.
Do not point the illuminated light directly at someone’s eyes.
Do not use Picture Light near people’s faces. Eyesight may be temporarily
affected leading to accidents.
EN60825-1:1994 A1:2002 & A2:2001
CAUTION:
Use of controls, adjustments or performance of procedure other than those
specified herein may result in hazardous radiation exposure. As the emission level
from Picture Light LED used in this product is harmful to the eyes, do not attempt
to disassemble the cabinet. Servicing is limited to qualified servicing station only.
Picture light source LED characteristics
a) Continuous illumination
b) Wavelength
White: $$-$$ nm
c) Maximum output
White: $$ mW(inside FOMA terminal $$ mW)
l
Before Using
Inserting UIM
1 Hook a finger on the tab and pull out the tray (1)
Pull out the tray straight until it stops.
2 Hold the UIM with the IC (gold) turned up and set on
the tray (2)
3 Push the tray all the way in (3)
ఈ
106
CLASS1
LED Product
Picture Light
123
Tab
Notch
Tray
Note that inserting or removing the UIM forcibly may damage the UIM or
deform the tray.
Attaching battery pack
2
1
3
Tabs
With a recycle mark
side up
6
5
Charging LED
External connector
terminal
External connector
terminal cover
Connector
(Turn the side with
the arrows up)
1
100V AC
outlet
Release buttons
1
1
2
Perform with the FOMA terminal turned off while holding with your both hands.
1 Push the catch of the back cover in the
direction of the arrow (1), slide the back
cover approximately 3 mm (2) and remove it
(3)
2 Attach the battery pack (4)
Turn a recycle mark side of the battery pack
up, match tabs and attach the battery pack.
3 Place the back cover to the FOMA terminal
slot with the back cover open approximately
3 mm, push it (5) and slide it (6) to the
direction of arrow to insert
Using unnecessary force when attaching or removing the battery pack may
damage the connector terminal for the battery pack (charger terminal) on the
FOMA terminal.
Securely close the back cover. If not closed securely, the back cover may
come off and the battery pack may fall out due to vibration.
Charging
1 Open the external
connector terminal cover
and insert the AC adapter
horizontally into the
external connector
terminal (1)
2 When inserting the AC adapter power plug into
an outlet, charge alert is heard, charging LED
illuminates, and charging starts
3 When charge alert is heard and charging LED
turns off, charging is complete
When removing the connector, always hold
the release buttons on both sides (1) and
unplug it horizontally (2).
Do not forcibly insert or remove. May cause damage to the external
connector terminal and the connector.
そ
の
他
107
Loading...
+ 9 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.