SUPPLEMENTARY MANUAL
SH9020C
Contents
GPS .............................................................................. 2
Specifications.............................................................. 2
Battery Time........................................................... 2
Safety Precautions and Conditions of Use.................2
Declaration of Conformity ........................................ 2
SAR....................................................................... 2
FCC NOTICE........................................................... 3
GPS
For a detailed explanation on how to operate the GPS functions,
refer to the following web site:
http://xxx
Safety Precautions and Conditions of Use
Declaration of Conformity
Specifications
Battery Time
Continuous Talk Time
Continuous Standby Time
Charging Time
(when the phone is turned off)
Note
• The above values were calculated with the battery installed.
• Continuous Talk Time is an average measured with a new, fully
charged battery, with stable signals.
• Continuous Standby Time is an average measured with a new,
fully charged battery, when the phone is closed without calls or
operations, in standby with stable signals.
• Talk Time/Standby Time may vary by environment, status,
settings, etc.
2GPS
Up to XXX minutes
Up to XXX hours
(when the phone is closed)
Approximately XXX minutes
(when charging with the AC charger)
Hereby, Sharp Telecommunications of Europe Limited, declares
that this SH9020C is in compliance with the essential requirements
and other relevant provisions of Directive 1999/5/EC.
A copy of the original declaration of conformity can be found at the
following Internet address:
http://www.sharp-mobile.com
SAR
Radio wave exposure and Specific Absorption Rate (SAR)
information
This mobile phone model SH9020C has been designed to comply
with applicable safety requirements for exposure to radio waves.
These requirements are based on scientific guidelines that include
safety margins designed to assure the safety of all persons,
regardless of age and health.
The radio wave exposure guidelines employ a unit of measurement
known as the Specific Absorption Rate, or SAR. Tests for SAR are
conducted using standardised methods with the phone transmitting
at its highest certified power level in all used frequency bands.
While there may be differences between the SAR levels of various
phone models, they are all designed to meet the relevant guidelines
for exposure to radio waves.
The SAR data conforms to the limit recommended by the
International Commission on Non-Ionizing Radiation Protection
(ICNIRP), which is 2 W/kg averaged over ten (10) grams of tissue.
The highest SAR value for this model phone tested by Sharp for use
0.475
at the ear is
W/kg (10g).
FCC NOTICE
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
Information to User
This equipment has been tested and found to comply with the limits
of a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation; if this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
1. Reorient/relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for
help.
CAUTION: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
FCC RF Exposure Information
The tests are performed in positions and locations (e.g., at the ear
and worn on the body) as required by the FCC for each model. The
highest SAR value for this model phone when tested for use at the
0.141
ear is
Body-worn Operation; This device was tested for typical body-worn
operations with the back of the phone kept 1.5 cm from the body.
To maintain compliance with FCC RF exposure requirements, use
accessories that maintain a 1.5 cm separation distance between
the user's body and the back of the phone. The use of belt-clips,
holsters and similar accessories should not contain metallic
components in its assembly. Use of other accessories may not
ensure compliance with FCC RF exposure guidelines.
W/kg and when worn on the body is 0.
411
W/kg.
Safety Precautions and Conditions of Use 3
Loading...