Date: Jul. 14, 1995
FONT WRITER: FW-700 etc.
[Service information]
No. : ETE-307
APPLICATION OF THE SCREW LOCKING AGENT
TO THE CARRIAGE BELT HOLDER
1. Model name: FW-500/600/700 (Production by SUKM)
2. General: The screw locking agent has been applied to the carriage belt holder in order to prevent the
belt from slipping out in the assembling work of the printer unit for the above models.
3. Description: Pay good attention to the following at exchanging or attaching the belt.
1) Remove perfectly the old screw locking agent applied.
2) Apply the new screw locking agent to the belt fixing part of the carriage.
3) Insert surely the belt into the belt fixing part.
4) Confirm that the applied screw locking agent is not pushed out after inserting the belt lest
printing should have bad influence with it.
Belt
Insert the belt after applying the screw locking agent to the slant-lined part.
Belt fixing guide
Belt fixing guide
Carriage
Belt mounting groove
Attaching bottom (Foot)
Belt
Belt fixing guide
Insert the belt to the end.
∗ Screw locking agent to use
THREE BOND made 1401C
Belt fixing guide
Belt
4. Application: From the middle of the April production in 1995
SHARP CORPORATION
Printer and Scanner Division
Orange
C