SHARP DTE381 Technical Report

Date : Jun. 3,1998

DUPLICATOR: SD-2260

1. Margin increase countermeasure against dispersion
of stop position of A3 thin sheet

2. Change of part in the transfer unit
(for better productivity)

3. Flameproofing margin increase of dust-tight filter

4. Shape change of part in the hand-supply section
(for better productivity)

1. Margin increase countermeasure against dispersion of stop position of A3 thin sheet

No. : DTE-381

1. Model Name: SD-2260

2. General: Since the stop position of the A3 size thin original sheet slightly disperses when RADF is used,

the electrostatic eliminating brush is bonded on the outlet of the paper supply section as the
countermeasure like SD-2275. Moreover, the sensor mylar is bonded in the timing sensor
section to prevent light leakage.

3. Action: From the 1st unit of production in May, 1998

SHARP CORPORATION Reprography Division

1/4

Green

C

2. Change of part in the transfer unit (for better productivity)

1. Model Name: SD-2060/2260/2275

2. General: To improve the productivity, some parts in the paper discharge section are changed as follows.

Changed part Change content
(1) SB driven roller Change of vendor maker
(2) Paper discharge guide, upper Change of vendor maker
(3) Paper discharge frame F Change of method to install the paper discharge

UM fixed shaft

(4) Paper discharge frame R Change of method to install the paper discharge

drive shaft A

3. Action: From the 1st unit of production in April, 1998

2/4