SHARP DTE362 Technical Report
Date: Feb. 27, 1998
DUPLICATOR SD-2260/2275
Countermeasure against abnormal noise during lift-up
of side cassette
1. Model Name: SD-2260/2275
2. General: Though it has been reported that "Change of hand-supply type paper supply unit (SD-2275)"
informed by the technical report (DTE-343, DTJ-361) already issued has been applied since 1st
No. : DTE-362
product mass-produced, it is found that the change sometimes causes a gear tooth to skip
between the gear 16/32T (P/G No. 40-30) and 32T gear (P/G No. 40 - 53) when the side cassette
is lifted up, thus possibly resulting in abnormal noise. As the countermeasure, the gear box
press-fitting spring is added (as shown below).
Note: When installing the spring, take care for the installing direction.
3. Action: 1st product in December, 1997
SHARP CORPORATION Reprography Division
1/2
Green
C
Ref.
Model
name
Version
No.
SD2260
1
SD2275
<Interchange>
1. Interchangeable. 4. Not interchangeable.
2. Current type can be used in place of new type.
New type cannot be used in place of current type.
3. Current type cannot be used in place of new type.
New type can be used in place of current type.
Parts marked with " " is important for maintaining the safety of the set. Be sure to replace these parts with specified ones
for maintaining the safety and performance of the set.
P/G No.
All 40 -
Current parts
Parts code
New parts
Parts code
MSPRT2706FCZZ
5. Interchangeable if replaced with same types of related
parts in use.
6. Others.
Price
rank
AC
Parts name
Gear box
press-fitting
spring
Effec-
tive
time
1st lot
’97/12
Inter-
change-
ability
6
Note
2/2
Loading...