SHARP DTE346 Technical Report

Date: Jan. 26, 1998
DUPLICATOR SD-2260
Countermeasure against static electricity in the intermediate tray section
1. Countermeasure against static electricity in the intermediate tray section
1. Model Name: SD-2260
2. General: Since paper charged in the intermediate tray is jammed at the paper guide, is poorly resupplied
No. : DTE-346
3. Description: Addition of electric discharging brush (Australia, UK and SEEG types only)
SHARP CORPORATION Reprography Division
1/2
Green
C
Addition of electric discharging sheet (all destinations)
Along with the above change, the export types of the intermediate tray units are changed as shown below.
2/2
4. Action:
After change
USA, Canada and general
representative types
DUNT-6860FC11
Before change
USA, Canada, SEEG,
Australia and general
representative types
USA, Canada, SEEG,
DUNT-6860FC12 UK type
Australia, UK and general
representative types
SEEG, Australia and UK types1st product of November, 1996 USA, Canada and general representative types1st product of February, 1997
Ref.
Model
No.
name
1 SD-2260
<Interchange>
1. Interchangeable. 4. Not interchangeable.
2. Current type can be used in place of new type. New type cannot be used in place of current type.
3. Current type cannot be used in place of new type. New type can be used in place of current type.
Parts marked with " " is important for maintaining the safety of the set. Be sure to replace these parts with specified ones for maintaining the safety and performance of the set.
Version P/G No.
Australia
UK
SEEG
30
ALL 30 -192
Current parts New parts
Parts code
-
PSHEZ4231FCZZ
Parts code
CBRSS0187FC01 AK
CBRSS0188FC01
Quantity change
2 →4
Parts name
Price
rank
Electric discharging brush A on the rear side
Electric discharging brush B on the rear side
AH
LIFT SHAFT DISCHARGE SHEET
5. Interchangeable if replaced with same types of related parts in use.
6. Others.
Effec-
tive
time
1st lot ’96/11
Inter-
change-
ability
6
Note
Loading...