SHARP DTE338 Technical Report

DUPLICATOR : SD-2260

Date

:

Jan. 9, 1998

No. : DTE-338

[Service Information]

EXPLANATION OF FRONT ACCESS MODE.
(FOR CONTINUOUS JOBS)

1.Model Name: SD-2260

2.General: It has been made possible to carry out continuous jobs (up to a maximum of two times)

during front access mode operations when model SD-2260 (After Main ROM V3.12)
and model SF-S55N are put in operation together, and therefore the explanation
described below is hereby reported.

3.Description: <1> when copy operations are carried out in either sort mode or staple sort mode after

the front access mode has been selected by the key operator program P51, and
the next job (in either sort or staple sort mode) is carried out as a continuous job,
the front access model has been made possible even when the two jobs finish at
the same time.
(The content of the change described above is only valid for up to two times per job.)

<2> In order for the mode described above to be made effective, it is necessary to run

simulation 26-04 as shown below, and carry out a change in the numeric value
from 0 to 1.

Sim.26-4-0 Old specifications.
Sim.26-4-1 The specifications described in <1> above have been made possible.

∗ The display that is sent to the LCD is the same as in Sim.26-4 (NO PROGRAM).

SHARP CORPORATION Reprography Division

Green

C