SHARP DTE335 Technical Report

DUPLICATOR : SD-2060

Date

:

Jan. 6, 1998

1. CHANGE IN THE PART CODES CARRIED OUT IN ACCORDANCE WITH A CHANGE THAT WAS CARRIED
OUT IN THE MAKER AS AN ACTION TO IMPROVE PRODUCTIVITY.

2. ACTION TO ESTABLISH INTERCHANGEABILITY FOR THE DV DRIVE PLATE, CARRIED OUT AS A
MEASURE TO IMPROVE PRODUCTIVITY.

3. ESTABLISHMENT OF REPLACEMENT PARTS CARRIED OUT IN ACCORDANCE WITH A HALT IN
PRODUCTION.

4. MEASURE TO ALLEVIATE PROBLEMS OF JAMS IN THE CENTER TRAY SECTION.

No. : DTE-335

1. Change in the part codes carried out in accordance with a change that was carried
out in the maker as an action to improve productivity.

1.Model Name: SD-2060/3062

2.General: There was a change that was carried out in the maker of the toner screw which is used

in the cleaner unit, and in accordance with this change a change has also been carried
out in the part code of the toner screw. This action has been carried out as a measure to
improve productivity. It is important to note that both the old and new parts are
interchangeable, and there is no problem in terms of using either one.

3.Action: From the 1st lot of 1996 June production.

2. Action to establish interchangeability for the DV drive plate, carried out as a
measure to improve productivity.

1.Model Name: SD-2060/3062

2.General: A change has been carried out in part of the shape of the developing drive plate D in the

drum drive unit. This action has been carried out as a measure to establish
interchangeability with other models. There is no problem in terms of using either the old
part or the new one for the models listed above.

Cut

Developing drive plate D

3.Action: From the 1st lot of 1996 August production.

SHARP CORPORATION Reprography Division

1/3

Green

C

3. Establishment of replacement parts carried out in accordance with a halt in
production.

1.Model Name: SD-2060/3062

2.General: The establishment of a replacement part for the IC (SRAM) used in the operations

control PWB has been carried out. This action has been carried out in accordance with a
halt in the production of the IC.

3.Action: Running change from 1996 mid-May production.

4. Measure to alleviate problems of jams in the center tray section.

1.Model Name: SD-2060/3062

2.General: There was a possibility of jams occurring in the center tray, caused by the rear edge of

the copy paper remaining in the movable paper guide section during paper feeding
operations. As a measure to alleviate this problem, the kick-out sheet has been
discontinued, and in the same location the addition of a rear edge brush has been
carried out.

Movable PG lower

Rear edge brush

P

Caution should be exercised
concerning the bristles of the brush

Rear edge block

3.Action: From 1996 mid-June production.

Rear edge block

Rear edge brush

2/3