SHARP DTE330 Technical Report
DUPLICATOR : SD-2260
Date
:
Dec. 4, 1997
1. DISCONTINUANCE OF THE DRY HEATER IN THE COOLING FAN
SECTION.
2. MEASURE TO ALLEVIATE PROBLEMS OF DIAGONAL FEEDING IN THE
3000 PAPER FEEDING TRAY.
No. : DTE-330
1. Discontinuance of the dry heater in the cooling fan section.
1.Model Name: SD-2260
2.General: The dry heater which was attached in the cooling fan section has been discontinued,
together with the attachment parts which accompanied the dry heater.
This action has been carried out as a measure to improve productivity.
These parts, however, will continue to be supplied as service parts.
34 Cooling fan section
Discontinued
3.Action: From the 1st lot of 1997 October production.
SHARP CORPORATION Reprography Division
1/2
Green
C
2. Measure to alleviate problems of diagonal feeding in the 3000 paper feeding tray.
1.Model Name: SD-2260
2.General: There has been a problem of diagonal feeding, which had been caused by the fact that
the upper limit detection sensor of the 3000 tray is positioned forward of the center of
the copy paper, and the actuator is pressed down by a spring, which creates resistance
during paper feeding operations. As a measure to alleviate this problem, the spring which
pressed the actuator down has been discontinued, which has relieved the resistance
which had been placed on the copy paper.
The spring has been discontinued,
relieving the pressure of the actuator.
F side of the
machine
Pressure had been applied forward of the
center of the copy paper by the actuator of
the upper limit detection sensor, which
sometimes resulted in diagonal feeding.
Center of the copy paper
3.Action: From the 1st lot of 1997 October production.
Ref.
No.
1
Model
name
SD-2260
Version P/G No.
Japan only
100V series CR-WZ0427FC02 Dry heater (120V)
200V series CR-WZ0430FC02 Dry heater (240V)
All
34 -2
34 -11
34 -12 LHLDW1013FCZZ Clamp holder
34 -1 XBPSD40P06K00 Screw (4 × 6K)
Current parts New parts
Parts code Parts code
CR-WZ0425FC02
Discontinued ----
LBNDJ0043FCZZ Snap band (SG-130)
Copy paper
Price
rank
Dry heater (100V)
Parts name
R side of the
machine
Effec-
Inter-
tive
change-
time
ability
1st lot
’97/10
6
Note
2/2
2
<Interchange>
1. Interchangeable. 4. Not interchangeable.
2. Current type can be used in place of new type.
New type cannot be used in place of current type.
3. Current type cannot be used in place of new type.
New type can be used in place of current type.
Parts marked with ‘‘ ’’ is important for maintaining the safety of the set. Be sure to replace these parts with
specified ones for maintaining the safety and performance of the set.
8 -63
MSPRT1146FCZZ
Q’ty Change
2 → 1
AA Separator spring
5. Interchangeable if replaced with same types of
related parts in use.
6. Others.
Loading...