SHARP DTE171 Technical Report

Date: Jul. 4, 1994

DUPLICATOR : SD-2060

1. PREVENTION OF DETACH OF HEAT WARNING LABEL FROM FUS ING COVER

2. PREVENTION OF PAPER FEEDING CLUTCH SLIP IN UDH PAPER FEEDING
DRIVE UNIT

3. PARTS CHANGES INSIDE THE STAPLER UNIT (TO IMPROVE PRODUCTIVITY)

1. Prevention of detach of heat warning label fusing cover

1.Model name: SD-2060 / 3062

2.General: Detach of heat warning label from fusing cover frequently occurred caused by high

temperature of attaching surface and changes of storage temperature. We changed
labels as follows to prevent it.

No. : DTE-171

3.Description: Materials of labels have been changed from wood free paper to polyester film (with
strong adhesive). Double-surface tape has been also attached on the surface of labels
with adhesive.
(Both the upper side and the side f ace of fusing cover have been changed in 120V for
USA, Canada, and Agent.)

4.Action: From the first unit of May 1994 production.

2. Prevention of paper feeding clutch slip in UDH paper feeding drive unit

1.Model name: SD-3062

2.General: Paper feeding malfunction of copy occurred caused by slip of paper feeding clutch that

drives UDH suction belt. We changed UDH as follows aiming to curb the load to
machine.

3.Description: (1)UDH paper feeding drive unit Discontinuance of mechanical load brake
(2)UDH suction belt Changes has been made to spacers that made

friction with suction belt.

SHARP CORPORATION Reprography Division

1/3

Green

C

(Curren t) (New)

Belt wing F ➀ Bel t wing F (0EUSHE 0 336D//) Q’ty: 2 → 1

(0EUSHE0336D//) Q’ty: 2 ➁ Belt wing F middle (0EUSHE0356D//) Q’ty: 0 → 1

Belt wing R ➀ Belt wing R (0EUSHE0337D//) Q’ty: 2 → 1

(0EUSHE0337D//) Q’ty: 2 ➁ Belt wing R middle (0EUSHE0357D//) Q’ty: 0 → 1

* Service parts are three ➀ from to ➂, as mentioned above, and are supplied as belt

wing FAS (0EUSHE 0336D01) and belt wing RAS (0EUSHE0335D01).
(Please refer to Parts List to get other changes’ information.)

4.Action: From mid-March 1994 production.

3. Parts changes inside the stapler unit (To improve productivity)

1.Model name: SD-3062

➂ Belt wing F upper (0EUSHE0354D//) Q’ty: 0 → 1

➂ Belt wing F upper (0EUSHE0355D//) Q’ty: 0 → 1

2.General: Caps of motor and Horizontal pins inside the stapler unit have been changed to
improve productivity.

3.Description:

We made changes in Caps color
of motor from black to ivory.

(Current type)

Black Ivory

(Cost reduction. There is no
change in function.)

(New type)

Changes in the forms of
Horizontal pins

(Current type)

(This was done to improve in function and to make
fixing spring more stable.)

(New type)

Horizontal pins

(Stapler unit from rear side.)

4.Action: From the first unit of May 1994 production.

2/3