SHARP DTE147 Technical Report
Date: Apr. 5, 1994
DUPLICATOR: SD-3062
1. PREVENTION OF SNAGING OF THE MODE CHANGE GATE IN
THE FINISHER UNIT.
2. IMPROVEMENT OF SLIDING OF THE JOGGER RACK IN THE
FINISHER UNIT.
No. : DTE-147
1. Prevention of snaging of the mode change gate in the finisher unit.
1.General: Spacers have been added in two locations to FIN frame F to prevent snagging of the
mode change gate and the upper sub paper guide in the finisher unit of model
SD-3062.
2.Description: Blower knife sheets have been added to FIN frame F as shown in the figure below.
FIN Frame F (LFRM-0776FCZ2)
(Front side)
Standard 0 ±1
Added blower knife sheet (shaded area)
(PSHEP2728FCZZ)
(Rear side)
Caution: The sheets should be attached to FIN
Frame F so that the attachment holes of
the FIN frame are not covered.
3.Action: (Factory action)
From 1994 January production.
SHARP CORPORATION Reprography Division
1/2
Green
C
2. Addition of grease to the jogger rack in the finisher unit.
1.General: White grease has been added to smooth the action of the jogger rack in the finisher
unit.
2.Description: White grease has been added to the jogger rack as shown in the figure below.
Grease should be applied to *1 and *2.
Cross section
*2 Gear area
Jogger rack
(NGERR0938FCZZ)
*1
Slide section of the boss
White grease (UKOG-0158FCZZ)
3.Action: (Factory action)
From 1994 January production.
Ref.
Model
No.
1 SD-3062 All
<Interchange>
1. Interc ha ng ea bl e. 4. N ot i nt er ch an ge ab l e.
2. Current type can be used in place of new type.
New type cannot be used in place of current type.
3. Current type cannot be used in place of new type.
New type can be used in place of current type.
Parts marked with “ ” is important for maintaining the safety of the set. Be sure to replace these parts with
spec i fi e d on es fo r m ai n ta in i ng t he s a fe ty and pe r fo r ma nce o f th e set.
name
Version P/G No.
Current parts New parts
Parts code Parts code
50
!
— PSHEP2778FCZZ AB
Price
5. Interchangeable if replaced with same types of
relate d parts in use .
6. Others .
Parts name
rank
Blower knife
sheet
Effec-
Inter-
tive
change-
time
’94/1 — Q’ty: 2
Note
ability
2/2
Loading...