SHARP DTE143 Technical Report

Date: Apr. 6, 1994

DUPLICATOR: SD-3062

1. CHANGE IN SHAPE OF THE INTER LOCK ATTACHMENT PLATE.

2. AT TACHMENT OF THE MIRROR MOTOR COVER.

1. Change in shape of the inter lock attachment plate.

1.Model name: SD-2060 / 3062

2.General: The shape of the inter lock attachment plate has been changed in accordance with the

inter lock protective cover. Note: The inter lock protective cover was reported in T/R No. DTE-132.

No. : DTE-143

3.Description: The shape of the inter lock attachment plate has been changed in four (4) places as shown in the figure below.

Change in shape

LPLTM4231FCZZ LPLTM4231FCZ1 (Old) (New)

4.Action: (Factory action)

(SD-3062): From 1993 November production. (SD-2060): From 1994 January production.

SHARP CORPORATION Reprography Division

1/3

Green

2. Attachment of the mirror motor cov er.

1.Model name: SD-3062

2.General: Once the finisher has been removed, the possibility remains that the user may touch

the mirror motor. To prev ent this from occurring, a mirror motor cover has been installed. A wire saddle has also been added to support the harness of the finisher.

3.Description: The mirror motor cover and the wire saddles have been installed in the locations shown in the figure below.

Added mirror motor cover PCOVP1188FCZZ

Added wire saddle LHLDW1154FCZZ

Added Wire saddle LHLDW1159FCZZ

LBSHC0297FCZZ Added edging (4 locations) Edging should be added only to the UDH hinges on the paper feed side.

UDH Hinge

Added bind S tight screws (M4 x 10) XHBSD40P10000 (2 locations)

4.Action: (Factory action)

From 1993 November production.

2/3

+ 1 hidden pages