SHARP DTE127 Technical Report

Date: Feb. 8, 1994

DUPLICATOR : SD-2060

[Service information]

No. : DTE-127

MIRROR MOTOR REPLACEMENT SEQUENCE.

1.General: The sequence for replacement of the mirror motor in model SD-2060 is not recorded in

the service manual, and is therefore described below .

2.Description: Mirror motor replacement procedure sequence.

1. Remove the upper left cabinet and the back cabinet (12 screws).

2. Disengage and remove the cooling fan attachment plate unit (4 screws). (It is also
possible to perform the operation through the holes in the A section of the figure below.
In this case, it is not necessary to disengage and remove the attachment plate unit of
the cooling fan.)

3. Loosen the set screws of the winding coupling area on the mirror motor side of the
unit.

4. Remove the mirror motor (4 screws).

5. Replace the mirror motor.

6. Install the new mirror motor by following this procedure in reverse sequence.

Caution: If the winding drive shaft remaining in the machine is moved toward the rear

once the mirror motor is disengaged and removed, the shaft socket in the front
of the machine becomes disengaged.

SHARP CORPORATION Reprography Division

1/2

Green

C

When loosening the set screws, first loosen ➁ and ➂, and afterwards ➀ and ➃.
When tightening the set screws, first tighten ➀ and ➃, and afterwards ➁ and ➂.

1

2

3

4

Winding coupling

Section A

Front side

➀

➁

Winding coupling

Winding drive shaft

➂

➃

Rear side

Mirror motor

2/2