SHARP DTE114 Technical Report

Date: Feb. 16, 1994

DUPLICATOR: SD - 3075

1. PARTS CHANGE IN THE STAPLER UNIT (TO ESTABLISH COMPATIBILITY).

2. CHAN GE IN THE CL CO N TROL CIRCUIT BOA RD AND TH E AC POWER S UP P LY CONTRO L
CIRCUIT BOARD (TO ESTABLISH COMPATIBILITY).

3. CHANGE IN PARTS CODES FOR THE RDH UNIT (ONLY FOR EXPORT MODELS BOUND FOR
THE UNITED STATES).

4. CHANGE IN THE FIXING LEAD WIRE.

No. : DTE - 114

1. Parts change in the stapler unit (To establish compatibility).

1. Model name: SD-F200 / F201

2. General: A portion of the assembly parts in the stapler unit have been changed to establish

compatibility with new models.

3.Description: The intermediate gears and motor gears have been changed.

Changed motor gear.

(0JVEH11108///)
(0JVEH11377///)

Changed intermediate gear.

Intermediate gear XP.

Changed intermediate gear.

(0JVEH11109///)

Intermediate gear 2.

(0JVEH11120///)

(0JVEH11109///)

(0JVEH11894///)

The three parts described above are to be replaced as a set when exchanging parts
during maintenance and servicing routines on machines already out on the market.

4.Action: (Factory action)
From 1994 February production.

SHARP CORPORATION Reprography Division

1/4

Green

C

2. Change in the CL control circuit board and the AC power supply control circuit
board (To establish compatibility).

1.Model name: SD-2075

2.General: The parts for model SD-2075 described below have been changed to those used in

models SD-3075 and 3076.

3.Description: The CL control circuit board and the AC power supply control circuit board have been
changed to establish compatibility with the models listed above.

4. Action: Service parts only.

3. Change in parts codes for the RDH unit (Only for export models bound for the
united states).

1.Model name: SD-2075

2.General: A change in the staple position label was reported in technical report no. DTE-072.

Though the code for the RDH unit had also been changed at the same time, it was not
reported.

3.Description: The code for the RDH unit of model SD-2075 has been changed as described below.

RDH unit change: DUNT-6379FC15 DUNT6379FC30

4. Action: From 1992 September production.

4. Change in the fixing lead wire.

1.Model name: SD-3075 / 3076

2.General: The lead wire of the fixing unit has been changed to alleviate the problem of wire

splitting.

3.Description: The lead wire has been changed from teflon to Zeigel. The thickness of the lead wire
has also changed due to the afore-mentioned change, and therefore the plastic clamps
have also been changed.

2/4