Sharp CP-SW1000H User Manual

MODEL

CP-SW1000H

SUBWOOFER SYSTEM

This Quick Start Guide will help you to correctly install and operate your system.

Accessories

Remote control x 1

RCA cable

(1 pin - 2 pins) x 1

Cleaning cloth x 1

RCA cable

(2 pins - 2 pins) x 1

Subwoofer

stand x 2

AC power lead x 1

Spike x 4

Foot cushion x 4

Remote control battery installation

Before using remote control

Before using remote control, please remove plastic shield at battery holder.

Plastic shield

Remote control

Battery holder

Turn on your system

Use the “CR 2025”, coin lithium battery.

1 Whilst pushing the locking tab towards the centre of

the remote control, slide out the battery holder.

Back of remote control

Locking tab

2 Remove the old battery from the battery holder, insert

the new battery and then slide the battery holder back into the remote control.

Battery holder

Positive (+) side up

Polarity (+) symbol

Locking tab

Battery type

1 Press the ON/STAND-BY button to turn the power on.

The volume indicator lights up blue.

(Lights

up blue)

2 To set the unit to stand-by mode:

Press the ON/STAND-BY button again. The STAND-BY indicator lights up red.

(Turns red)

TINSEA210AWZZ 07H R AS 1

Subwoofer preparation

Make sure to unplug the AC power lead before installing the main unit or changing the position.

Select from three installation methods according to the preferred position.

Horizontal position

Using spikes

Using foot cushions

Tighten all spikes as shown

Attach the foot cushions as shown

Vertical position

Place subwoofer stand as shown

Stand

Subwoofer connections to TVs

H Connecting to a TV

To audio output sockets

Audio cable (supplied)

To AUDIO INPUT sockets

Subwoofer

H Connecting to a TV (with subwoofer pre-out)

To SUBWOOFER PRE-OUT socket

Audio cable (supplied)

To AUDIO INPUT sockets

Subwoofer