LASER PRINTER: JX-8200(only bound for the BG/BK)
No. : CLE-061
ADDITION OF A CORE CARRIED OUT TO THE
I/F HARNESS OF THE PWB IN THE ICU.
1.Model Name: A3JX8200BG
A3JX8200BK
2.General: The addition of a core has been carried out to the I/F harness which connects the PWB
of the ICU with the AP board or the Network board.This action has been carried out as a
measure to comply with EMIstandards.
3.Description: The addition of the core to the I/F harness (DHAI-0116GCZZ)has been carried out in
the following two stages.
<1> Temporary action.
ICU PWB unit: DUNTK0121GCZZ → DUNTK0121GC12
A 2-partition core has been attached to the I/F harness with core holders
(this action has been carried out between April and June productions.)
A non-partition core
Assy has been used
from July production.
Position of the core standard.
Separate by about 5 mm.
<2> Permanent action.
The core used in the temporary action described above has been changed to
a non-partition type core Assy to the I/F harness (from July production).
I/F harness: DHAI-0116GCZZ → DHAI-0116GCZ1
4.Action: <1> Temporary action: From 1998 April production to June production.
<2> Permanent action: From 1998 July production.
SHARP CORPORATION Reprography Division
1/2
Green
C
Ref.
Model
No.
JX-8200 BG/BK
<Interchange>
1. Interchangeable. 4. Not interchangeable.
2. Current type can be used in place of new type.
3. Current type cannot be used in place of new type.
Parts marked with " " is important for maintaining the safety of the set. Be sure to replace these parts with
specified ones for maintaining the safety and performance of the set.
Version P/G No.
name
---- DUNTK0121GCZZ DUNTK0121GC12 CZ ICU PWB unit '98/4
3 -1
New type cannot be used in place of current type.
New type can be used in place of current type.
Current parts New parts
Parts code Parts code
DHAI-0116GCZZ DHAI-0116GCZ1 BC I/F harness '98/7
Price
5. Interchangeable if replaced with same types of
related parts in use.
6. Others.
Parts name
rank
Effec-
tive
time
Inter-
change-
ability
3
Note
2/2