SHARP CLE053 Technical Report

LASER PRINTER : JX-8200

Date

July. 6, 1998

No. : CLE-053

ADDITION CARRIED OUT OF TWO CAPACITORS ATTACHED TO THE BACK SIDE OF THE ICU PWB.

1.Model Name: JX-8200 (All destination)

2.General: There have been problems of a printer drops in the ICU PWB after the sending of

printing data. As a measure to alleviate this problem the addition of two (2) capacitors has been carried out to the back side of the PWB.

3.Description: Sandwich capacitor (0.1 µF) RC-K1E104HCZT × 2

The new capacitors have been added in the locations described in the figure shown below.

<1> One capacitor is soldered between the through-hole of the GND and the

through-hole of the Vcc on the soldered face at IC 1 (G10).

<2> One capacitor is soldered between the through-hole of the GND and the

through-hole of the Vcc on the soldered face at IC 5 (CPU). (Caution: After the soldering operations have been completed, the soldered portion should be check by lightly touching them with a finger to insure that they are firmly and properly attached.)

SHARP CORPORATION Reprography Division

1/2

Green

4.Action: From 1998 February production.

Ref.

Model

No.

1 JX-8200 All ---- ---- RC-K1E104HCZT AA Sandwich capacitor 0.1µ F '98/2 6

1. Interchangeable. 4. Not interchangeable.

2. Current type can be used in place of new type.

3. Current type cannot be used in place of new type.

Parts marked with " " is important for maintaining the safety of the set. Be sure to replace these parts with

specified ones for maintaining the safety and performance of the set.

Version P/G No.

name

New type cannot be used in place of current type.

New type can be used in place of current type.

Current parts New parts

Parts code Parts code

5. Interchangeable if replaced with same types of related parts in use.

6. Others.

Price

rank

Parts name

Effec-

tive

time

Inter-

change-

ability

Note

2/2