SHARP CLE032 Technical Report

COLOR LASER PRINTER : JX-8200

Date

May. 11, 1998

No. : CLE-032

MEASURE TO ALLEVIATE PROBLEMS OF ABNORMAL

NOISE FROM THE CYAN MG CLUTCH.

1.Model Name: A3JX-8200 AU/AL/BK/BG/BA

2.General: There was a problem of obstruction between the E-ring of the MG clutch and the

shutter idle gear 26, causing the possibility of abnormal noise being generated from the cyan MG clutch. As a measure to alleviate this problem, a change has been carried out in the thickness of the teeth of the shutter idle gear 26. The teeth were previously 5 mm in width, but this has been changed to 4 mm. In accordance with this change, the application of grease to the E-ring section and the gear teeth has been discontinued.

3.Description:

E-ring

Shutter idle gear 26

Obstruction

4.Action: From 1998 March production.

Ref.

Model

No.

JX-8200 All

1. Interchangeable. 4. Not interchangeable.

2. Current type can be used in place of new type.

3. Current type cannot be used in place of new type.

Parts marked with ‘‘ ’’ is important for maintaining the safety of the set. Be sure to replace these parts with

specified ones for maintaining the safety and performance of the set.

Version P/G No.

name

4 -30

New type cannot be used in place of current type.

New type can be used in place of current type.

Current parts New parts

Parts code Parts code

NGERH0126GCZZ NGERH0126GCZ1 AD Shutter idle gear 26 ’98/3 3

Description of change in the shutter idle gear 26

Effec-

Price

rank

5. Interchangeable if replaced with same types of related parts in use.

6. Others.

Parts name

tive

time

Inter-

change-

ability

Note

SHARP CORPORATION Reprography Division

Green