DIGITAL COPIER(OPTION) : AR-DE1/FN1
1. CORRECTION CARRIED OUT IN THE PARTS GUIDE FOR MODEL AR-DE1.
2. MEASURE TO ALLEVIATE PROBLEMS OF ABNORMAL NOISE CAUSED BY
SKIPPING OF THE COUPLING GEARS AND MEASURE TO ALLEVIATE
PROBLEMS OF ROLLER MARKS LEFT ON THE COPY PAPER BY THE PAPER
DELIVERY ROLLER.
No. : ARE-118
1. Correction carried out in the parts guide for model AR-DE1.
1.Model Name: AR-DE1
2.General: There was a change that was carried out in the part code from the 1st lot of mass
production. In accordance with this change a change has been carried out in the parts
guide.
Old New
Parts guide [5] -1 0EUGID0406J// → 0EUGID0406JZ1
2. Measure to alleviate problems of abnormal noise caused by skipping of the coupling
gears and measure to alleviate problems of roller marks left on the copy paper by
the paper delivery roller.
1.Model Name: AR-FN1
2.General: There were some problems of abnormal noise which occurred due to skipping of the
coupling gears (the paper delivery roller gears) of the 2-bin paper delivery reversion unit
in the main machine when model AR-FN1 was loaded. There were also some problems
of roller marks left on the copy paper from the paper delivery rollers. As a measure to
alleviate this trouble, the action described below has been carried out.
3.Description: <1> The coupling gear (paper delivery roller gear) has been changed to a one-way
clutch gear.
<2> The pressure spring of the driven roller has been removed. (An explanation has
been provided in the service manual.)
When carrying out the changes described above to model AR-FN1 machines produced
before the effective time described below, it is necessary to change the ROM of the FIN
main PWB to version 2.10 or later.
For model AR-FN1 machines produces after the effective time described below, the
one-way clutch gear and the installation procedures have been included in the shipping
boxes, and the ROM of the FIN main PWB is set to a version later than V 2.10.
It is important to note that when loading model AR-FN1, it is not necessary to have had
the changes described in <1> and <2> above carried out.
1/3
SHARP CORPORATION Reprography Division
Green
C
4.Action: * Japanese domestic production: From the 1st lot of 1998 August production.
Overseas general sales representatives: From the 1st lot of 1998 August production.
UK: From the 1st lot of 1998 September production.
SEEG: From the 1st lot of 1998 September production.
Australia: From the 1st lot of 1998 September production.
USA: From the 1st lot of mass production.
Ref.
Model
No.
1 AR-DE1
2 AR-FN1 ---- ---- NGERH1285FCZZ AL One-way gear * 6
<Interchange>
1. Interchangeable. 4. Not interchangeable.
2. Current type can be used in place of new type.
3. Current type cannot be used in place of new type.
Parts marked with " " is important for maintaining the safety of the set. Be sure to replace these parts with
specified ones for maintaining the safety and performance of the set.
Version P/G No.
name
5 -1
All
New type cannot be used in place of current type.
New type can be used in place of current type.
Current parts New parts
Parts code Parts code
0EUGID0406J// 0EUGID0406JZ1 AY Transport stay upper 1st lot 3
Price
rank
5. Interchangeable if replaced with same types of
related parts in use.
6. Others.
Parts name
Effec-
tive
time
Inter-
change-
ability
Note
2/3