Page 1
INSTALLATION IS COMPLETE!
5
SAFETY WARNINGS
1 Select a well-ventilated location.
2 Avoid exposing this set to direct sunlight,
dust, heat sources or moisture.
3 Do not place objects containing liquids on
top of the TV.
4 Never open the back cover.
5 Never insert objects into the TV.
6 Take care not to damage the power cord.
7 Keep the TV from strongly magnetic
objects.
NOW LET’S GET STARTED
66FW-53H
76FW-53H
COLOUR TELEVISION
QUICK
SHARP ELECTRONICA
ESPAÑA, S. A.
START
GUIDE
Refer to the Operation Manual for:
Channel selection .................................. P.11
Picture adjustments............................... P.12
Audio adjustments.................................. P.16
Timer settings (ON/OFF Timer)............... P.20
Child lock................................................ P.22
Menu structures...................................... P.24
Teletext mode......................................... P.25
SHARP ELECTRONICS
(U.K.) LTD.
Sharp House, Thorp Road, Newton Heath,
Manchester M40 5BE
PRINTED IN SPAIN
TINS-6704BMN4
5/01
for easy installation
● Fitting the batteries into the remote control
● Connecting the aerial cable
● Tuning the TV channels
Using this installation
guide should enable you
to set up your TV in less
than 15 minutes - - -
- - - Please refer to your
operation manual for
more tips and advice
If problems persist contact the SHARP (office hours) Helpline on tel:08705 274277
(or (01) 676 0648 if telephoning from Ireland) and/or WEB-SITE: www.sharp.co.uk/support
Page 2
1
SUPPLIED ACCESSORIES
2
Back of TV
®
Mains Socket Outlet
AC 220~240 V, 50 Hz
4
TYPICAL CONNECTIONS (continued)
AUTO INSTALLATION
The AUTO INSTALLATION function will tune all available
TV stations into your TV.
The TV is ready to preset automatically all local channels
for you.
If you do not intend to use your TV with
a VCR then please proceed to stage 4.2
2
Remote control
Type-AA Dry Batteries
Fitting the batteries
1. With your
thumb nail,
pull up the slit
as shown.
2. Insert the two
batteries as
shown.
TYPICAL CONNECTIONS
Operation Manual
3. Replace the
cover.
Printed on recycled paper
3
SCART Lead
(Not supplied)
RF out
Aerial
(Not supplied)
Aerial in
Aerial Lead
(Not supplied)
A scart lead (not supplied) is recommended for use with this TV, to obtain
the best communication between your TV and VCR, please refer to page37 of the operation manual.
BACK OF VCR
Audio/Video
Mains Socket Outlet
AC 220~240 V, 50 Hz
Aerial Cable
(Not supplied)
Check List:
● Is the TV connected to the mains?
● Is the aerial connected to the TV?
Note: for Satellite/Cable or digital decoder page 37 of operation manual.
TURN TV ON FOR THE FIRST TIME
TV set
1 Press the main power button (®)
to start the AUTO INSTALLATION.
2 The orange power indicator will light.
VCR
1 If the TV is being used
with a VCR, turn on the
VCR and
pre-recorded tape.
2 Now, press any button
on the TV remote
control and follow the
instructions on the
screen, to start Auto
Channel Preset.
This tuning process may
take several minutes to
perform.
3 After searching has
finished the channels
will be stored in the
following order:
Pr01 - BBC1,
Pr02 - BBC2,
Pr03 - ITV,
Pr04 - CH4...
The "Stored programmes" menu will appear on screen
and you can change the order of the channels and change
or give the channels a four letter name.
If you wish to rename the channels, or change the order,
refer to the pages 9 and 10, chapter Stored programmes
in the Operation Manual
play back a
Pr 01
Automatic searching and sorting
Press the menu button to cancel
Mains Socket Outlet
AC 220~240 V, 50 Hz
3 The AUTO INSTALLATION
message will appear on your TV
screen, and after a time will change
for another with electrical connetions
Note:
If you need to repeat the “AUTO
INSTALLATION”, please refer to the
relevant section on page 29 of the
operation manual.
If you wish exit from the menu, press the BLUE button.
Loading...