Page 1
Page 2
FULLY MODULAR AND RYZEN COMPATIBLE
Due to the fully modular cable system only the cables are used on the power supply which are actually required for
connecting the hardware and peripherals. The complete cabling and the case interior remain tidy, and the airflow is
not unnecessarily hindered. Because of sockets for two 4+4-pin CPU connectors, 100% compatibility with
AMD RYZEN mainboards is guaranteed.
Page 3
80 PLUS GOLD CERTIFIED
The SilentStorm Cool Zero has been certified with 80 PLUS Gold, achieving at
least 90% efficiency at 50% load as well as 87% efficiency at 20% and 100% load.
This validates that the power supply is highly cost effective and suitable for
energy conscious users.
HIGH QUALITY
COMPONENTS
The exclusive use of Japanese capacitors, rated to 105°C, and a 135 mm fan
with a fluid dynamic bearing provide a quiet and reliable operation with an
average life cycle of over 100,000 hours.
Page 4
SELECTABLE FAN FUNCTIONS
ZERO RPM MODE
The Zero RPM mode enables a noise free operation
at low to moderate loads. When the mode is deactivated, the fan runs at low speed to produce a constant airflow.
FAN SPEED
RPM
FAN DELAY MODE
When the fan delay mode is activated, the power
supply fan continues to run for 60 seconds after the
system has been switched off. Thus hot spots can be
avoided, and remaining waste heat is transported
out of the system.
This function depends on surrounding
conditions and can therefore vary.
Warmth
Page 5
COOLING OPTIONS FOR VARIOUS
INSTALLATION POSITIONS
POWER SUPPLY ON THE
CASE BOTTOM:
When the power supply is positioned below in
the case, cool air is drawn from underneath the
case and transported to the rear out of the
housing as waste heat. The air circulation of the
power supply is largely separated from the air
circulation in the rest of the case. Here, the use
of Zero RPM mode is particularly recommended
as the air intake is only needed for cooling the
power supply, and the fan rotation can be stopped for noiseless operation over especially long
periods. When necessary, the fan delay mode
provides additional dissipation of warmth from
the power supply when the system is turned off.
PSU
PSU
POWER SUPPLY
UNDERNEATH TOP PANEL:
When the power supply is positioned above in
the case, warm air is drawn in from the inside of
the casing and transported to the rear out of the
case. The air circulation of the power supply is
combined with the air circulation in the rest of
the case. When the Zero RPM mode is off, air
circulation in the upper part of the case is provided, effectively cooling voltage regulators of
water cooling systems, for example. Since the
heat level in the entire housing is constantly
raised, the use of the fan delay mode is particularly recommended. This helps to protect
all installed components and increase their
service life.
Page 6
CONNECTION OPTIONS AND
CABLE DIAGRAM
550 mm
1x
24-Pin Mainboard Connector
550 mm
150 mm
600 mm
550 mm
150 mm
150 mm
150 mm
150 mm
2x
4+4-Pin CPU Connector
RYZEN Compatibility
2x
2x 6+2-Pin PCIe Connector
3x
4x SATA Connector
Adapter Cable
1x
(SATA to Floppy)
2x
Adapter Cable (SATA to IDE)
INCLUDED
CABLE BAG
Page 7
STABILITY AND LONGEVITY
FOR YOUR HARDWARE
ULTRA-STABLE
VOLTAGE REGULATION
< 1 %
Intel Specifications
Sharkoon Voltage Regulation
-5 % +5 %
12 V
LOW RESIDUAL RIPPLE
20 mV
120 mV
OPTIMIZED
SAFETY AND
Sharkoon Residual Ripple
With modern LLC resonant converter
technology, the power supply unit
provides a constant and reliable
voltage with minimum noise and
heat levels.
PROTECTION
The SilentStorm Cool Zero supports all
common safety functions with over current
and over voltage protection, under voltage
protection, short circuit protection and over
temperature and over power protection. In
addition, the device corresponds to CE, FCC
and CB safety standards.
Page 8
SPECIFICATIONS
Model
Input (AC)
Output
Voltage (DC)
Max. Output
Current
Max. Combined
Power
Total Power
Model
Input (AC)
Output
Voltage (DC)
Max. Output
Current
Max. Combined
Power
Total Power
SilentStorm Cool Zero 650
Voltage
Current Frequency
100 V - 240 V ~ 10 A 50 Hz - 60 Hz
+3.3 V +5 V +12 V
22 A
22 A
120 W
54.2 A
650 W
-12 V +5 Vsb
0.3 A 3 A
3.6 W 15 W
650 W
SilentStorm Cool Zero 750
Voltage
Current Frequency
100 V - 240 V ~ 10 A 50 Hz - 60 Hz
+3.3 V +5 V +12 V
22 A
22 A
120 W
62.5 A
750 W
-12 V +5 Vsb
0.3 A 3 A
3.6 W 15 W
750 W
Model
Input (AC)
Output
Voltage (DC)
Max. Output
Current
Max. Combined
Power
Total Power
SilentStorm Cool Zero 850
Voltage
Current Frequency
100 V - 240 V ~ 10 A 50 Hz - 60 Hz
+3.3 V +5 V +12 V
22 A
22 A
120 W
70.9 A
850 W
-12 V +5 Vsb
0.3 A 3 A
3.6 W 15 W
850 W
Loading...