Shark S5003A Quick Start Manual

For questions or to register your product, contact us at:

800-798-7398 or visit us online at sharkclean.com

@sharkcleaning

WHAT’S INSIDE:

For additional part s and accessories, visit sharkclean .com

QUICK START GUIDE

ASS EM B LY

STEAM POCKET® MOP SYSTEM

With Intelligent Steam Control

Use this Quick Start Guide to learn about your new Shark Genius Steam Pocket Mop System’s great features.

S5003A_D_160 614

Steam Mop Handle

Steam Mop Body

Filling Flask

Genius™ Mop Hea d

Dirt Grip™ Pad

Triangle Scrubber

Triangle Scrub Pad

(Click)

Filling the Water Tank

Pull down on the water tan k cap to open. Use the ﬁlling ﬂask to po ur water into the tank. Do n ot overﬁll. Press the wate r tank cap ﬁrmly to close it.

TO REMOVE the Genius™ Mop Head, pres s the release button on the front of the mop body.

Steam Pocket® Mop Assembly

STEAM POCKET MOP

Please be sure to read the enc losed Owner’s Guide prior to using you r unit.

STEAM BL ASTER™ TECHNOLOGY

GENIUS™ MOP HEAD TECHNOLOGY

CLEANING TROUBLESHOOTING

DIRT GRIP™ PA DS

TOUCH-FREE PAD ATTACHMENT

USING YOUR STEAM POCKET

MOP

With the Genius™ Mop Head, you can quickly and easil y attach and release the Dirt Grip™ Pads without touching them . No more wrestling with dirty, wet pads . The Dirt Grip Pads are double-sided, wa shable and reusable. For p ad attachment and removal in structions, see the following page.

Your Steam Mop is ideal fo r deep cleaning and cut ting through dirt and grime in high -trafﬁc areas, as we ll as for sanitizing* s ealed hard ﬂoors.

*Sanitization studies were cond ucted under controlled test conditions . Household conditions and results may vary. With Geniu s Mop Head in HI mode only when used with Steam Mop. Not when using Steam Blaster. See Owner ’s Guide for instructions.

The unit will be in standby m ode as soon as it is plugged in.

The 3 lights below the Steam b utton will blink while in standby mo de.

To select the steam mode, pres s the Steam button once for LOW (1 blue ligh t), twice for MED (2 blue light s), or three times for HI (3 blue lights).

SETTING

IDEAL FOR THESE SEALED SURFACES

RECOMMENDED USAGE

LOW

Laminate Hardwood Marble

Light cleaning and dusting Loosening and lifting light dirt

MED

Hardwood Marble Tile Stone

Cleaning most sealed surfaces and large areas Basic, everyday cleaning Removing spots and smaller messes Cleaning moderate and heavy-trafﬁc areas

Hardwood Marble Tile Stone

Deep cleaning and cleaning hard-to-clean surfaces Tough cleaning and removing stuck-on messes and stains Deep cleaning heavy-trafﬁc areas Cutting through heavy dirt and grime Sanitizing* ﬂoors

PROBLEM POSSIBLE REASONS & SOLUTIONS

The Steam Mop isn’t producing any steam.

The Steam Mop should be securely plugged into an electrical outlet. Check your fuse or circuit breaker or try a different outlet. Make sure the water tank is full, the unit is plugged in, and the light around the Steam Control button is solid. If the lights below the Steam Control Button are not illuminated, try a different electrical outlet. If the lights below the Steam Control Button are blinking, press the Steam Control button to select a Steam setting. If the lights below the Steam Control Button are solid, wait 30 seconds for the unit to warm up. If after following the above steps the Steam Mop still does not produce any steam, contact Customer Service at 1-800-798-7398 or consumer-services at sharkninja.com

The Steam Mop is producing intermittent steam.

This is normal—for more consistent steam select the HI setting. Also, make sure the water tank is full.

I can’t select a Steam Setting.

Make sure the Steam Mop is plugged in and the lights below the Steam Control Button are solid. If your Steam Mop is producing steam but the lights below the Steam Control Button are not lit, call customer service at 1-800-798-7398.

I am getting streaky/cloudy ﬂoors.

The Dirt Grip™ Pad might be dirty. If it is, ﬂip it over to the clean side or change it entirely. If you washed the Dirt Grip Pad with powdered detergent, then it could be damaged and require replacement. This could also be an indication of soap or grease residue that has accumulated on the ﬂoor. As the Steam Mop uses only a small amount of water, it may not be enough to rinse off the accumulation of residue that the steam is bringing to the surface. We suggest rinsing the ﬂoor with nothing but water, letting it dry, and then steam mopping again with a clean Dirt Grip Pad. One or more rinses will generally remove the residue. A more stubborn case may require you to rinse the ﬂoor with a mix of one part vinegar and two parts water* (but DO NOT put any cleaning solutions or chemicals into the Steam Mop's water tank.)

* Please consult your ﬂooring manufacturer’s care and maintenance

instructions before applying any cleaning products or solutions.

It’s really hard for me to push/pull the Steam Mop.

The Steam Mop might be hard to push/pull if the Dirt Grip Pad isn’t wet enough. It should get easier to push/pull the Steam Mop after it’s been running for a few minutes. An overly dirty pad could also result in a harder push/pull experience. We recommend ﬂipping the pad over or using a clean pad.

DOUBLE-SIDED, WASHABLE, REUSABLE

Our washable Dirt G rip Pads are made with ﬁbers spe cially designed to absorb and tr ap dirt. This gives your ﬂoors an am azing clean, with minimal strea king and short dry times .

For best cleaning re sults, we recommend r eplacing your Dirt Grip Pads fol lowing 20 normal uses .

PAD CARE

Machine wash the Dir t Grip Pads separately with warm water using liquid deterge nt.

NEVER USE BLE ACH, POWDERED DETERG ENT, OR FABRIC SOFTENE RS as they may damage

the Dirt Grip Pads.

You can purchase replaceme nt Dirt Grip Pads and other accessories by vi siting sharkclean.com or calling 1-80 0-798-7398.

Some parts may be availa ble at your local retailer. Contact Customer S ervice for any other servicin g.

1. L ift the mop straight up by th e

handle until the Genius Mop Head is hanging straight down . Press the pad release button , and both sides of the head will drop op en, releasing the pad.

REMOVING THE PAD

STEAM

POCKET MOP

3 4

1. Li ft the mop straight up by the handl e

until the Genius Mop Head is hanging straigh t down. Center the Ge nius Mop Head above the pad. Press the release button on the back of the mop body, and both sides of the mop head will drop open.

3. Gently press the Genius Mo p Head to the

ﬂoor on one side of the pad, and that side will click into place.

4. Flip the other side of the head over onto

the ﬂoor to click into place.

2. Slip the mop head’s 4 corner tabs

into the 4 corner pockets of the Dirt Grip™ Pad.

STEAM

POCKET® MOP

When you need an extra burst of steam to clean tough, dried messes and stuck-on stain s, use the Steam Blaster.

1. Flip the Genius™ Mop Head over so that it is behind the mop body.

2. Tilt the mop handle back. This will cause the Steam Blaster to emit a concentrated blast of steam onto the ﬂoor.

To stop the Steam Blaster

spray, simply tilt the mop handle forward.

4. Flip the Genius Mop Head back into its original position and continue cleaning.

Shark S5003A Quick Start Manual

Specifications and Main Features

Frequently Asked Questions

User Manual