IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
For Household Use Only
WHEN USING YOUR SHARK
STEAM MOP, BASIC SAFETY
PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING:
WARNING:
TO
REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK OR INJURY
READ ALL INSTRUCTIONS
BEFORE USING YOUR
STEAM MOP.
DANGER OF SCALDING.
Please use caution when
using the steam mop. The steam
emitted from the steam mop is
very hot.
POLARIZED PLUG:
This appliance has a polarized
plug (one blade is wider than
the other). As a safety feature,
this plug will fit into a polarized
outlet only one way. If the
plug does not fit fully into the
outlet, reverse the plug. If it still
does not fit, contact a qualified
electrician. Do not attempt to
defeat this safety feature.
1. Use the system only for its
intended use.
2. DO NOT use outdoors.
3. DO NOT leave the appliance
unattended when plugged in.
Always unplug the power cord
from the electrical outlet when not
in use and before servicing.
4. DO NOT allow to be sued as a toy.
DO NOT allow the appliance to be
used by children. Close attention
is necessary when used by or near
children, pets or plants.
5. Use only as described in this
manual.
6. Use only manufacturer’s
recommended accessories.
7. DO NOT operate this appliance if
it is not working as it should, with
a damaged plug or cord, if the unit
has been dropped, damaged, left
outdoors, or dropped in water.
To avoid the risk of fire, do not
disassemble or attempt to repair
the appliance on your own. Return
the appliance to EURO-PRO
Operating LLC for examination and
repair. Incorrect re -assembly or
repair can cause a risk of electrical
shock or injury to persons when
the appliance is used.
8. To protect against a risk of electric
shock, DO NOT immerse the steam
mop into water or any other liquids.
9. DO NOT handle plug or steam
mop with wet hands or operate
appliance without shoes .
10. DO NOT pull or carry by power
cord, use power cord as handle,
close a door on the power cord, or
pull the power cord around sharp
edges or corners. Keep power cord
away from heated surfaces.
TOL L F RE E: 1-80 0-79 8-739 8
Eng lis h
11. DO NOT unplug by pulling on
power cord. To unplug, grasp the
plug not the power cord. Do not
use extension cords or outlets
with inadequate current carrying
capacity.
12. DO NOT put any objects into
openings. Do not use with any
opening that is blocked.
13. DO NOT put hands or feet under
the steam mop. Unit gets very hot.
14. Use ONLY on flat, horizontal
surfaces. Do not use on walls,
counters or windows .
15. DO NOT use on leather, wax
polished furniture or floors,
synthetic fabrics, velvet or other
delicate, steam sensitive materials.
16. DO NOT add cleaning solutions,
scented perfumes, oils or any other
chemicals to the water used in this
appliance as this may damage the
unit or make it unsafe for use. If
you live in a hard water area, we
recommend using distilled water in
your steam mop.
17. When in use, NEVER turn the
appliance over or on its side.
NEVE R DIRECT STEAM TOWARDS
PEOPLE, ANIMALS OR PLANTS.
18. NEVE R LEAVE THE STEAM MOP
IN ONE SPOT ON ANY SURFACE
FOR ANY PERIOD OF TIME WHEN
MICRO -FIBER PAD IS ATTACHED
AS THIS WILL DAMAGE YOU R
FLOORS.
19. Carefully remove the micro-fiber
cleaning pad immediately after you
have unplugged and allowed the
steam mop to cool.
20. When cleaning the steam mop,
unplug the power cord from the
electrical outlet and clean with a
dry or damp cloth. Do not pour
water or use alcohol, benzene or
paint thinner on the unit.
21. Extreme caution should be
exercised when using this
appliance to clean stairs .
22. Never use steam mop without
micro-fiber cleaning pad attached.
23. Keep your work area well lit.
24. Store steam mop indoors in a cool,
dry place.
25. To avoid circuit overload, do not
operate another appliance on the
same socket (circuit) as the steam
cleaner.
26. DO NOT run appliance over
the power cord. If an extension
cord is absolutely necessary, an
extension cord rated a minimum
of 15 ampere, 14 gage cord should
be used. Cords rated for less
amperage may overheat. Care
should be taken to arrange cord so
that it cannot be pulled or tripped
over.
27 Always unplug and allow the steam
mop to cool before removing or
changing mop heads.
WARNING: Your steam mop
is designed to clean hard floor
surfaces that will withstand high
heat. Do not use on unsealed wood
or unglazed ceramic floors . On
surfaces that have been treated
with wax or some no wax floors,
the sheen may be removed by the
heat and steam action. It is always
recommended to test an isolated
area of the surface to be cleaned
before proceeding. We also
recommend that you check the use
and care instructions from the floor
manufacturer.
ww w.s harkcl ea n. com
This manual covers model number: S3601A 11
TECHNICAL SPECIFICATIONS
Voltage: 120V., 60Hz.
Power: 1550 Watts
Water Capacity: 500ml (16.9 oz.)
TOL L F RE E: 1-80 0-79 8-739 8
Contents
Eng lis h
Thank you for
purchasing
®
the Shark
Pro
Steam Pocket
Mop.
Getting Started ......................................................................2
Using Your Steam Mop .......................................................5
Using Your Carpet Glider ...................................................9
®
Care of Your Steam Mop ....................................................10
Troubleshooting Guide ....................................................... 12
Warranty ...................................................................................13
ww w.s harkcl ea n. com
1
Getting Started
When assembling your steam mop there
may be a little water in or around the
water tank. This is because we test all
our steam mops 100% before you buy
them, so you get a quality Shark® Pro
Steam Pocket® Mop.
a
b
c
d
e
f
g
h
i
j
l
k
m
a All-Purpose Mop Head (1),
and Triangle Mop Head (1)
b Steam Mop Body
c Mop Handle
d Two-Sided Micro-Fiber Cleaning Pads
for the All-Purpose Mop Head (3),
and Triangle Mop Head (2)
e (1) 6mm x 54mm Large Screw*
f Filling Flask
g Carpet Glider
2
TOL L F RE E: 1-80 0-79 8-739 8
h Quick Release Swivel Cord Wrap
i Cord Clips
j Water Tank Cap
k Water Tank
l ON/Standby Switch
m Mop Head Release Button
*Phillips or flat head screwdriver can be
used. Screwdriver not included.