WHEN USING YOUR SHARK®
STEAM MOP, BASIC SAFETY
PRECAUTIONS SHOULD
ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS
BEFORE USING YOUR STEAM
MOP.
DANGER OF SCALDING.
Please use caution when
using the steam mop. The steam
emitted from the steam mop is
very hot.
IM PO RTA NT:
This appliance can be used
by children aged from 8 years
and above and persons with
reduced physical or mental
capabilities or lack of experience
and knowledge if they have
been given supervision or
instruction concerning the use
of the appliance in a safe way
and understand the hazards
involved. Children shall not play
with the appliance. Cleaning
and user maintenance shall not
be made by children without
supervision.
This appliance is not intended
for use by persons (including
children) with reduced physical,
sensory or mental capabilities,
or lack of experience and
knowledge, unless they have
been given supervision or
instruction concerning the use
of the appliance by a person
responsible for their safety.
1. Use the system only for its
intended use.
2. DO NOT use outdoors.
3. DO NOT leave the appliance
unattended when plugged in.
Always unplug the power cord
from the electrical outlet when not
in use and before servicing.
4. DO NOT allow the appliance to be
used by children. Close attention
is necessary when used by or near
children, pets or plants.
5. Children should be suprevised to
ensure that they do not play with
the appliance.
6. Use only as described in this
manual.
7. Use only manufacturer’s
recommended accessories.
8. DO NOT operate the appliance
with a damaged plug or cord, or
if the unit has been dropped or
damaged. To avoid the risk of
electric shock, do not disassemble
or attempt to repair the appliance
on your own. If the supply cord
is damaged, it must be replaced
by a qualified electrician in order
to avoid a hazard. Incorrect reassembly or repair can cause a
risk of electrical shock or injury
to persons when the appliance is
used.
9. To protect against a risk of electric
shock, DO NOT immerse the steam
mop into water or any other liquids.
10. DO NOT handle plug or steam
mop with wet hands or operate
appliance without shoes.
11. DO NOT pull or carry by power
cord, use power cord as handle,
close a door on the power cord, or
pull the power cord around sharp
edges or corners. Keep power cord
away from heated surfaces.
12. DO NOT unplug by pulling on
power cord. To unplug, grasp the
plug not the power cord. Do not
use extension cords or outlets
with inadequate current carrying
capacity.
13. DO NOT put any objects into
openings. Do not use with any
opening that is blocked.
14. DO NOT put hands or feet under
the steam mop. Unit gets ver y hot.
15. Use ON LY on flat, horizontal
surfaces. Do not use on walls,
counters or windows.
16. DO NOT use on leather, wax
polished furniture or floors,
synthetic fabrics, velvet or other
delicate, steam sensitive materials.
17. DO NOT add cleaning solutions,
scented perfumes, oils or any other
chemicals to the water used in this
appliance as this may damage the
unit or make it unsafe for use. If
you live in a hard water area , we
recommend using distilled water in
your steam mop.
18. When in use, NEVER turn the
appliance over or on its side.
NEVE R DIRECT STEAM TOWARDS
PEOPLE, ANIMAL S OR PL ANTS .
19. N EVER LEAVE THE STEAM MOP
IN ONE SPOT ON ANY SURFACE
FOR ANY PERIOD OF TIME WHEN
MICROFIBRE PAD IS ATTACHED
AS THIS WILL DAMAGE YOUR
FLOORS.
20. Carefully remove the microfibre
cleaning pad immediately after you
have unplugged and allowed the
steam mop to cool.
21. When cleaning the steam mop,
unplug the power cord from the
electrical outlet and clean with a
dry or damp cloth. Do not pour
water or use alcohol, benzene or
paint thinner on the unit.
22. Extreme caution should be
exercised when using this
appliance to clean stairs.
23. Never use steam mop without
microfibre cleaning pad attached.
24. Keep your work area well lit.
25. Store steam mop indoors in a cool,
dry place.
26. To avoid circuit overload, do not
operate another appliance on the
same socket (circuit) as the steam
cleaner.
27. If an extension cord is absolutely
necessary, an extension cord rated
a minimum of 15 ampere, 14 gage
cord should be used. Cords rated
for less amperage may overheat.
Care should be taken to arrange
cord so that it cannot be pulled or
tripped over.
28. DO NOT leave your Steam Mop
unattended when the system is
connected to a power supply
/electrical outlet.
29. DO NOT store unit with damp or
wet microfibre cleaning pocket
attached. Never leave the steam
mop in one spot on any surface
for any period of time with a damp
or wet microfibre cleaning pocket
attached as this will damage your
floors.
30 Always unplug and allow the steam
mop to cool before removing or
changing mop heads.
WARNING:
Your steam mop is designed to
clean hard floor surfaces that will
withstand high heat. Do not use
on unsealed wood or unglazed
ceramic floors . On surfaces that
have been treated with wax or
some no wax floors, the sheen may
be removed by the heat and steam
action. It is always recommended
to test an isolated area of the
surface to be cleaned before
proceeding. We also recommend
that you check the use and
care instructions from the floor
manufacturer.
SAVE THESE
INSTRUCTIONS
Quick Start
When assembling your steam mop
there may be a little water in or around
the water tank. This is because we test
all our steam mops 100% before you
buy them, so you get a quality
®
Shark
Steam Mop.
1
3
ASSEMBLE
1 Insert the mop handle into the
pump actuator (the tube that leads
to the tank). Push the mop handle
and pump actuator together in
until you hear it click into place.
2 Select a mop head and cleaning
pad. Fit one side of the pocket
onto the head first, then using
the lavender loop, pull the pocket
over the head. Attach the quick
fasteners on the top of the pocket
to secure in place.
3 Snap the mop head into the base to
secure it. Press the release button
to exchange mop heads.
2
4
FILL
4 Lay the mop on the floor or on
a counter top and remove the
water tank cap by turning counter
clockwise. Fill the water tank using
the filling flask. Do not overfill the
water tank. Replace the water cap
and tighten.
IM P O R TA NT: Make sure your floors
are sealed. Before using the Steam
Mop consult page 4 for more
information.
Quick Start
5
QUICK
TIP: For
easier
pushing
and pulling,
extend the
handle length
6
DIRT CAN’T HIDE ON
EITHER SIDE! All new
design allows for optimal
cleaning! When one side
of the pocket gets dirty,
just turn the mop head
over and clean with the
other side of the pocket.
PREPARE
5 For your comfort, you can adjust
the height of the mop. Just lift the
latch on the tube 90 degrees to the
open position. Holding the handle,
extend the tube to the height that’s
right for you and then close latch to
locked position.
6 Plug in mop and wait 30 seconds
or less for the mop to heat up.
Pump the handle of the mop by
pushing downward about 10 to 12
times to create steam.
NOTE:Steam is created
automatically when you start
mopping.
QUICK TIP: We’ve added an
additional mop head. You can
now choose from a Rectangle
mop head for all the rooms in your
house or the Triangle mop head
that is perfect for bathrooms and
tight spaces.
NOTE: Do not leave your Steam
Mop unattended during use.
IM P O R TA NT: Never leave the
steam mop in one spot for any
period of time with a damp or wet
microfibre pocket attached as this
will damage your floors.
This appliance complies with the WEEE-Directive 2002/96/EC on the disposal of
electrical and electronic equipment (WEEE).
This appliance complies with the European directives for electromagnetic
compatibility (EMC) 2004/108/EC and its revisions, as well as Low Voltage
Directive (LVD) 2006/95/EC and its revisions.
This marking indicates that this product should not be disposed with
other household wastes throughout the EU. To prevent possible
harm to the environment or human health from uncontrolled waste
disposal, recycle it responsibly to promote the sustainable reuse of
material sources. To return your used device, please use the return
and collection systems or contact the retailer where this product
was purchased. They can take this product for environmental safe
recycling.
This product has no on/off switch and operates when plugged into the main supply
source. Disconnect the plug from mains after use.
Although the product is not provided with standby mode or off mode, it still fulfills
the requirements of 1275/2008/EC - the directive for Eco-Design requirements
since according to technical justification, it is considered as inappropriate to provide
standby and off modes when connecting to mains. To reduce energy consumption
be sure to unplug the unit after use.
TECHNICAL SPECIFICATIONS
Voltage: 230V~, 50/60Hz.
Power: 1550 Watts
Water Capacity: 450 ml
Not to be disposed
of with other
household waste.
IPX4
Loading...
+ 14 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.